Atmel AT43301 Manual 

Text of Atmel AT43301 Manual 

• Full Compliance with USB Spec Rev 1.1

• Four Downstream Ports • Full-speed and Low-speed Data Transfers • Bus-powered Controller • Bus-powered or Self-powered Hub Operation • Port Overcurrent Monitoring • Port Power Switching • 5V Operation with On-chip 3.3V Regulator • 24-pin SOIC Description The AT43301 is a 5-port USB hub chip supporting one upstream and four down- stream ports. The AT43301 connects to an upstream hub or h

The AT43301 consists of a Serial Interface Engine, a Hub

Repeater, and a Hub Controller. The Serial Interface Engine’s tasks are: • Manage the USB communication protocol • USB signaling detection/generation • Clock/data separation, data encoding/decoding, CRC generation/checking • Data serialization/deserialization The Hub Repeater is responsible for: • Providing upstream connectivity between the selected device and the host • Manag

Input, Schmitt Trigger

O = Output OD = Output, open drain B = Bi-directional V = Power supply, ground Table 1. Pin Assignment in Numerical Order Pin# Signal Type 1 VCC V 2 VSS V 3 CEXT1 O 4 OSC1 I 5 OSC2 O 6 LFT I 7 STAT OD 8 PWR OD 9 OVC IS 10 LPSTAT IS 11 TEST I 12 SELF/BUS IS 13 VSS V 14 DM0 B 15 DP0 B 16 DM1 B 17 DP1 B 18 DM2 B 19 DP2 B 20 DM3 B 21 DP3 B 22 DM4 B 23 DP4 B 24 NC - Table 2. Pin Assignment i

The Atmel AT43301 USB hub controller chip contains vari-

ous features that makes it the ideal solution for very low- cost USB hubs. These features are: on-chip regulator, low- frequency oscillator, bus or self-powered operation, ganged port power switching and global overcurrent pro- tection. Such a hub can be a stand-alone hub used with portable computers to allow convenient connectivity to standard desktop periphe

The Hub Repeater is responsible for port connectivity setup

and teardown. It also supports exception handling such as bus fault detection and recovery, and connect/disconnect detection. Port0 is the root port and is connected to the root hub or an upstream hub. When a packet is received at Port0, the AT43301 propagates it to all the enabled down- stream ports. Conversely, a packet from a downstream port is transmitted from Port0. The

In the bus-powered mode all the power for the hub itself as

well as the downstream ports is supplied by the root hub or upstream hub through the USB. Only 100 mA is available for each of the hub’s downstream devices and therefore only low-power devices are supported. The power switch works exactly like the self-powered mode, except that the allowable switch resistance is higher: 140 mΩ or less under the worst case condition.

The Hub Controller of the AT43301 provides the mecha-

nism for the host to enumerate the hub and the AT43301 to provide the host with its configuration information. It also provides a mechanism for the host to monitor and control the downstream ports. The Hub Controller supports two endpoints, Endpoint0 and Endpoint1. The Hub Controller maintains a status register, Controller Status Register, which reflects the AT43301’s current

Atmel Controller Owners Instructions: