iFactory3D One Extension Quick Start Manual
Text of the manual
Dismantle the M4x20 screws in the scraper.
Remove the scraper and the metal plates with
holes.
Fasten the feet at the rear end of the 20x20
profiles as shown in the picture.
Mount the profile covers at the end of both 20x20
profiles, if you don’t want to use a second
extension.
Pull out the extendable feet.
Fasten them if two sliding blocks are in the profile
end while the other two are outside.
Slide the 20x20 profile onto the feet until it
touches the 20x20 profile from the first extension
and fasten it there.
Slide the feet from the second extension into the
20x20 profiles and fasten them.
Place the plate over the spacers and fasten it with
M5x30 screws to the 20x20 profiles.
Make sure that the extension/s are at the same
level as the belt.
Use the M5x35 screws to adjust the level of the
extension. We highly recommend using a spirit
level for this purpose.
Also make sure, that the floor of the machine is
level.
