Delta 40-530 Instruction Manual

(Model 40-530) PART NO. 900621 (011) Copyright © 2001 Delta Machinery ESPAÑOL: PÁGINA 15 To learn more about DELTA MACHINERY visit our website at: www.deltamachinery.com. For Parts, Service, Warranty or other Assistance, please call 1-800-223-7278 (In Canada call 1-800-463-3582). ...

are certain hazards involved with the operation of the product. Using the machine with respect and caution will considerably lessen the possibility of personal injury. However, if normal safety precautions are overlooked or ignor ...

SCROLL SAWS 3 19. DO NOT feed the material too fast while cutting. Only feed the material fast enough so that the blade will cut. 20. NEVER start the tool with the stock pressed against the blade. 21. WHEN cutting a large workpiece, MAKE SURE the material is supported at table height. 22. USE CAUTION when cutting material which is ...

POWER CONNECTIONS A separate electrical circuit should be used for your tools. This circuit should not be less than #12 wire and should be protected with a 20 Amp time lag fuse. If an extension cord is used, use only 3-wire extension cords which have 3-prong grounding type plugs and 3-pole receptacles which accept the tool� ...

cord is in good condition and is a 3-wire extension cord which has a 3-prong grounding type plug and a 3-pole receptacle which will accept the tool’s plug. When using an extension cord, be sure to use one heavy enough to carry the current of the saw. An undersized cord will cause a drop in line voltage, ...

TACHMENTS NOT RECOMMENDED BY DELTA MAY RESULT IN RISK OF INJURY. WARNING: TO AVOID INJURY FROM ACCIDENTAL STARTING, ALWAYS TURN SWITCH “OFF” AND RE- MOVE POWER CORD FROM ELECTRICAL OUTLET BEFORE REMOVING OR REPLACING BLADE. 1. Remove the blade from the upper blade holder. (See the section “ ...

section “CHANGING BLADES”, begin with instruction #6). 7. Assemble table insert (C) Fig. 9, to table as shown. NOTE: Opening in table insert (C) should be positioned toward the front for normal work with the table in the level position and should be positioned toward the right when tilting the table. F ...

STORAGE A convenient wrench and blade holder (A) Fig. 13, is supplied on the left side of the rear casting, which allows you to store the quickset blade changing wrench (B) and extra scroll saw blades when not in use. A B Fig. 13 CHANGING BLADES WARNING: THE USE OF ACCESSORIES OR AT- TACHMENTS NOT RECOMMENDED BY DELTA MAY RESULT IN RISK O ...

changing wrench into hole (G) in lower blade holder. This will automatically align wrench (C) with blade holder screw (H). 7. Turn wrench (E) Fig. 17, counterclockwise to loosen screw (H) and remove blade (F) from lower blade holder. 8. Insert new blade into the lower and upper blade holders in the same man ...

The table (A) Fig. 20, on your scroll saw can be tilted up to 45 degrees to the left for bevel cutting operations. 1. Turn the table insert 90 degrees to the right. NOTE: ROTATE THE TABLE INSERT TO ALLOW YOU TO TILT THE TABLE WITHOUT BENDING OR BREAKING THE BLADE. 2. Loosen table lock handle (A) Fig. 20. Tilt table (B) Fig. 20, to the d ...