IBC Water AST0715MP-960 Installation & Operating Instructions Manual

INSTRUCTIONS Model : AST0715MP-960 Serial No : ……………………….. Telephone: (07) 3219 2233 Facsimile: (07) 3219 2266 Email: [email protected] Website: www.ibcwater.com.au FILTRATION & WATER TREATMENT PROD ...

WATER SOFTENER PERFORMANCE DATA SHEET Automatic Model No. Capacity & Salt Dosage Recommended Maximum Service Flow Rate Pipe Size Resin Volume Approx. Shipping Weight (kg) Space Required Minimum Maximum Inlet Outlet Drain W x D x H gram/kg gram/kg Flow LPM mm mm Litres Per Kg metres AS0715MP-960 525 ...

TO PACKAGE THE VALVE WITH THE TOP STRAINER SUPPLIED LOOSE. IT IS IMPORTANT THAT THIS STRAINER IS ASSEMBLED TO THE VALVE DURING INSTALLATION. THE LENGTH OF THE INTERNAL RISER PIPE IS FACTORY ADJUSTED FOR THE TANK SIZE PROVIDED. DO NOT SHORTEN THIS PIPE UNDER ANY C ...

THE MICROPROCESSOR CONTROL WILL REQUIRE BASIC DATA PROGRAMMING TO SUIT THE WATER HARDNESS AND DESIRED UNIT CAPACITY IMPORTANT: IT IS ESSENTIAL THAT YOU READ THE GENERAL CONDITIONER INFORMATION AND CONTROL SETTINGS OF THIS MANUAL BEFORE ATTEMPTING TO SET THE FUNCTIONS OF THIS UNIT. THE DEALER OR AGE ...

FITTED WITH MODEL 255 VALVE/960 CONTROL Check the equipment upon arrival for damage or shortages and report same to our Office or agent before starting. Position the Softener Cabinet on a firm foundation, preferably concrete, with sufficient space for operation and maintenance. ...

Note: For a full understanding of your water softener we advise that the instruction manual provided with the softener should be fully read. After the water softener has been fully installed with the correct amount of salt placed in the brine cabinet or external brine tank it will be nec ...

Using the æò buttons, key in the current last minute figure. Eg, AM 11.25 – Key in ‘5’ Press the ï button - the first minute digit will blink. Using the æò buttons, key in the current first minute figure. In example 11.25 – Key in ‘2’ Press the ï button – the second hour dig ...

Wait till the green light moves to the “TIME OF DAY” position Immediately press “SET” button. The last digit will blink – Using the ï button, key in the current last minute figure. Eg, PM 03.25 – Key in ‘5’ Press the ï button - the first minute digit will blink. Using the æò butto ...

Note: this program will only accept a figure rounded to the nearest “TEN”. Eg for a hardness of say 183 the 190 will have to be programmed in the setting ie the next higher “TEN” number will have to be selected. Wait till the green light moves to the “TIME OF DAY” then using the ò bu ...

the resin bed. Before this is done proceed as follows: • Turn power off • Make sure inlet water to softener valve is “OFF”, outlet valve “OFF” and bypass open • Verify that drain line is fitted and that there is an “AIR GAP” ...