Front Runner FAJK010 Read Me First

Text of the manual

Jeep Wrangler JKU 2 Door (2007-2018)

inner brackets and Foot Rail FAJK010 / FAJK011_REV_A01 © 2020 FRONT RUNNER VEHICLE OUTFITTERS 1 IMPORTANT WARNING! Don’t be a hero and muscle through this without first reading these fitting instructions! Improper installation of this gear may void certain aspects of your warranty. Before you begin, take a moment

FAJK010 / FAJK011_REV_A01

© 2020 FRONT RUNNER VEHICLE OUTFITTERS 2 IN THE BOX FIGURE 1.1 IN THE BOX TOOLS NEEDED T40 Torx Wrench IN THE BOX 2 9 8 4 6 3 5 8 9 3 7 10 1 GET ORGANIZED FAJK011 13MM 10MM 10MM 13MM 4mm 22mm (7/8") Hole Saw 1RH 1LH 1 2 X Inner Bracket 1LH + 1RH 2 2 X Inner Bracket Clamp 3 16 X M6 Nut Cap 4 8

© 2020 FRONT RUNNER VEHICLE OUTFITTERS

3 FAJK010 / FAJK011_REV_A01 12R 1 GET ORGANIZED FIGURE 1.2 IN THE BOX 11 10 X M8 X 20 Hex Bolt 12 2 X Foot Rail - 1LH + 1RH 13 10 X M8 x 16 x 1.6SS Flat Washer 14 10 X M8 Nyloc Nut 15 10 X M8 Nut Cap IN THE BOX IN THE BOX 11 13 14 15 FAJK010 Rear Of Veh

© 2020 FRONT RUNNER VEHICLE OUTFITTERS

4 FAJK010 / FAJK011_REV_A01 4 FIT AND SECURE 2 13mm 2.1 2.2 2.3 Remove the two T-top roofs. Disconnect the power socket and water pipe in the back left corner of the vehicle. Using a T40 Torx Wrench, remove the six torx bolts holding the rear roof to the vehicle's body. Remove the two torx bolts either side of the fron

© 2020 FRONT RUNNER VEHICLE OUTFITTERS

5 FAJK010 / FAJK011_REV_A01 4 FIT AND SECURE 2 13mm 2.4 2.5 2.6 Remove the speaker box so that you have access to the zips and padding that cover the vehicles roll bars. This is done by removing the six bolts that hold it in place. Two bolts on the outside of each speaker and one bolt either side of the screw that hold

© 2020 FRONT RUNNER VEHICLE OUTFITTERS

6 FAJK010 / FAJK011_REV_A01 4 FIT AND SECURE 2 13mm 2.7 2.8 2.9 If not already assembled, assemble your Tray as per the Universal Tray Assembly Instructions (Document RRSTUNI) Clean the area around all the 22mm holes drilled in the roof with a rag and methylated spirits/denatured alcohol. Insert the Aluminum Space

© 2020 FRONT RUNNER VEHICLE OUTFITTERS

7 FAJK010 / FAJK011_REV_A01 4 2 2.10 FIT AND SECURE With the help of a friend, flip the Tray end over end so that it is in the upright position. (The Tray is flipped end over end so that bolts and brackets do not slide left and right). With one of you on either side of the Tray, lift the Tray and walk it into positio

© 2020 FRONT RUNNER VEHICLE OUTFITTERS

8 FAJK010 / FAJK011_REV_A01 4 TAKE A TRIP 4 After your first adventure, check that all nuts, bolts, screws and fittings are tight. Re-tighten where needed. You'll find a small amount of settling has happened. Go on many more adventures, periodically checking all nuts, bolts, screws and fittings. 4.1 Front Runner ca

Other Automobile Accessories Manuals