Habitat HTE-01 Programming Manual

This manual uses special attention icons to alert the user of (1) Important safety concerns, (2) Instructions on proper operation of control functions and (3) Installation/set up information. Safety: Indicates a condition which may cause severe personal injury, death or major property damage. Important Information: Indicates information w ...

New York, NY 10016 Customer Service Toll Free: 1-800-717-1682 Web Site: www.habitattechnologies.com [email protected] Manual Table of Contents About This Manual HTE-01 Thermostat - Home Screen Display HTE-01 Thermostat - Controls HTM-01 Base Module - LED Status Indication HTE-01 Thermostat ...

Connected Not connected 8 Time display 2 WIFI status indicator (only shown when WIFI module is in use.) Connected Not Connected 9 Override status indicator: Override – Temporary Override Perm. Override – Permanent Override 3 Thermostat Battery power indicator status, only shown when on battery power. Full Half Low Replac ...

display icons. – Increase or Decrease the target temperature set point. Changing the target set point: • Press the or button while in Auto, Heat or Cool Modes. • If a schedule is programmed, “Override” is displayed below the time indicating that the current target setpoi ...

LED Status Indication. HTM-01 Base Module LED Status Indication LED Status Indication State Description Flashing Green Pairing Base module is seeking to pair with the thermostat. Green Paired Base module is paired with the thermostat. Red Not Paired Base module is not paired with a thermo ...

Pair additional base module(s) Daylight Savings Time (DST)1 or Toggle DST or Month1 Set Month (MM) 1 to 12 Date1 Set Date (DD) 1 to 31 Year1 Set Year (YY) Hour1 Set Hour (HHAM/PM) Minute1 Set Minute (MM) 1 to 59 Emergency Heat Toggle or Setback Enable Toggle - 1,2 - 2 Setbac ...

hold down the Mode and Fan buttons until a beep sounds (3 seconds), then release. Press to identify base modules. “All” flashes indicating all modules. Press to scroll through the list of connected base modules. If any module has been paired but has lost its link to the Thermostat, the pairing status indicator will blink along w ...