H3C PSR2400-54A Operation & User’s Manual

User Manual New H3C Technologies Co., Ltd. http://www.h3c.com Document version: 6PW105-20181116 ...

and its licensors All rights reserved No part of this manual may be reproduced or transmitted in any form or by any means without prior written consent of New H3C Technologies Co., Ltd. Trademarks Except for the trademarks of New H3C Technologies Co., Ltd., any trademarks that may be mentioned in this d ...

Front panel ···································································· 2 LEDs ········································� ...

swappable and provides a maximum output of 2400 W. Table 1 PSR2400-54A power module features Feature Description Protection Protection against input undervoltage, input overvoltage, output overvoltage, output short circuit, output undercurrent, output overcurrent, and overheat. Redundancy ...

(1) Power input LED (AC OK) (2) Handle (3) AC input receptacle (4) Latch (5) Power output LED (DC OK) (6) Air outlet vents LEDs The PSR2400-54A power module has two LEDs. 1 2 6 3 4 5 ...

LED Mark Color Description Power input LED AC OK Off No AC power input. Low AC input voltage. The power module has entered self-protection mode. Green Normal AC input. Power output LED DC OK Green Normal DC output. Red A DC output failure has occurred, for example, output short circuit, output overcurrent, output overvoltage, output ...

16 A Maximum output current 44.5 A Maximum output power • 1200 W @ 110 VAC • 2400 W @ 220 VAC Dimensions (H × W × D) 41 × 100 × 332 mm (1.61 × 3.94 × 13.07 in) Ambient temperature Operating temperature –10°C to +50°C (–14°F to +122°F) Storage temperature –40°C to + 70°C (–40°F to +158°F) P ...

module Installing the power module To avoid bodily injury and device damage, follow the procedures in Figure 2 to install a power module. Figure 2 Power module installation procedure Before the installation, prepare an ESD wrist strap and a flat-blade screwdriver yourself. Installing the power module 1. Wear an ESD wrist s ...

{ If the blank panel is as shown in Figure 3, thread the flat-blade screwdriver through the hole in the handle of the blank panel and pull the blank panel out. { If the blank panel is as shown in Figure 4, put your forefinger in the hole in the blank panel and pull the blank panel out. Figure 3 R ...

3. Unpack the power module. 4. Correctly orient the power module. If you install the power module in a left power module slot, make sure the latch is above the handle. If you install the power module in a right power module slot, make sure the latch is below the handle. 5. Holding the handle of the power module with one ...