H3C S12500-X Command Reference Manual

VXLAN Command Reference Hangzhou H3C Technologies Co., Ltd. http://www.h3c.com Software version: Release 1135 and later Document version: 6W101-20151130 ...

All rights reserved No part of this manual may be reproduced or transmitted in any form or by any means without prior written consent of Hangzhou H3C Technologies Co., Ltd. Trademarks H3C, , H3CS, H3CIE, H3CNE, Aolynk, , H3Care, , IRF, NetPilot, Netflow, SecEngine, SecPath, SecCenter, Se ...

references describe the commands and command syntax options available for the H3C S12500-X & S12500X-AF Switch Series running Release 1135 and later. The VXLAN Command Reference describes the commands for configuring VXLAN. This preface includes: • Audience • Co ...

example, the New User window appears; click OK. > Multi-level menus are separated by angle brackets. For example, File > Create > Folder. Symbols Convention Description WARNING An alert that calls attention to important information th ...

at http://www.h3c.com. Click the links on the top navigation bar to obtain different categories of product documentation: [Technical Support & Documents > Technical Documents]—Provides hardware installation, software upgrading, and software feature configurat ...

Basic VXLAN commands ················································································ ...

ovsdb server bootstrap ca-certificate ···································· ...

FC cards cannot provide VXLAN IP gateway services. An FE or FX card cannot connect to a user site if it acts as a centralized VXLAN IP gateway. Before you can configure VXLANs, you must perform the following tasks: • Set the system operation mode: a. Set the system operating mode to standard by usi ...

system-view [Sysname] vsi vsi1 [Sysname-vsi-vsi1] arp suppression enable Related commands • display arp suppression vsi • reset arp suppression vsi description Use description to configure a description for a VSI. Use undo description to delete the description of a VSI. Syntax descript ...

Views Tunnel interface view Predefined user roles network-admin mdc-admin Parameters ipv4-address: Specifies an IPv4 address. Examples # Specify the source address 193.101.1.1 and destination address 192.100.1.1 for Tunnel 1 on Sysname 1. system-view [Sysname1] interface tunnel 1 mode vxl ...