BYOC Large Beaver Ram’s Head Instructions Manual

Large Beaver Ram’s Head Kit Instructions Warranty: BYOC, Inc. guarantees that your kit will be complete and that all parts and components will arrive as described, functioning and free of defect. Soldering, clipping, cutting, stripping, or using any of the components in any way voids this guarantee. BYOC, Inc. guarantees that the i ...

kit in a satisfactory manor. Nor does BYOC, Inc. promise or guarantee that you will receive any technical support. Purchasing a product from BYOC, Inc. does not entitle you to any amount of technical support. BYOC, Inc. does not promise or guarantee that any ...

Index Parts Checklist……………………….................…....page 6 Populating the Circuit Board…….................…...…..page 8 Main PCB Assembly..................................................page 17 Wiring……………………………….........................page 19 Installing the IC/Fi ...

Resistors 1 - 120Ω* (Brown/Red/Black/Black/Brown) or (Brown/Red/Brown/Gold) 2 - 150Ω (Brown/Green/Black/Black/Brown) or (Brown/Green/Brown/Gold) 1 - 1k (Brown/Black/Black/Brown/Brown) or (Brown/Black/Red/Gold) 1 - 3k3 (Orange/Orange/Black/Brown/Brown) or (Orange/Orange/Red/Gold) 1 - 4k7 (Yellow/Purple/B ...

WITH A PAIR OF NEEDLE NOSE PLIERS 2 - A100k (SUSTAIN, LEVEL) 1 - B100K (TONE) Hardware: 1 - predrilled enclosure w/ 4 screws 1 - Large Beaver Ram’s PCB 1 - 3pdt footswitch 1 - SPDT On-On Toggle Switch 1 - SPDT On-Off-On Toggle Switch 2 - Enclosed Audio Jacks 1 - Battery Snap 4 - rubber bumpers ...

Step 1: Add all the resistors. Resistors are not polarized and can be inserted in either direction. Be aware that the 120 Ohm resistor and the 10k resistors have similar band colors. To help differentiate the two, you can look at the 10k and 120 Ohm resistors side by side. The 120 Ohm resistor will be slightly different in that t ...

stripe to the layout on the PCB. The striped end should go in the square solder pad. ...

the flat side on the PCB layout. ...

and can go in either orientation. The capacitors highlighted in yellow are the ceramic disc capacitors. ...

meaning there is a positive and negative end. The positive side will have a longer lead and goes in the square solder pad. The negative side will have a shorter lead and a stripe running along the body of the cap, and goes in the round solder pad ...