Friedrich EMRT-1 Instruction Manual

Thermostat with an Occupancy Sensor PART NO. 94993003_01 INSTRUCTION MANUAL ...

Introduction.............................................................................................................5 Before You Begin....................................................................................................6 Programming a Thermostat with a Network Programmer......................................7 Thermosta ...

18 – MAXIMUM SET POINT................................................................................36 19 – TEMPERATURE CONTROL MODE............................................................37 20 – AUTO CHANGEOVER SET POINT OFFSET..............................................38 21 – SETBACK SET POINTS / AUTO-RESTORE........... ...

deliver unprecedented energy savings without compromising guest comfort. Integrated occupancy sensor uses a combination of motion and thermal sensing technologies for accurate occupancy detection. Reliable occupancy detection allows saving energy when rooms are unoccupi ...

➤ ➤ Determine the appropriate installation location for the thermostat. The thermostat should face the bed area of the room. ➤ ➤ Set the PTAC/Vert-I-Pak unit to “External Thermostat” (Class 2) mode. Consult the PTAC/Vert-I-Pak unit documentation to determine how to set the PTAC/Vert-I-Pak unit to “External Thermostat” mode. ...

In case of Network Installation with Remote Management, the thermostat must be programmed with a Network Programmer specific to the property before the installation. Thermostat must not be powered during the pairing procedure.. ➤ ➤ Plug one programmer connector into the thermostat; ➤ ➤ Push the bla ...

Mounting the thermostat to the wall ➤ ➤ Unplug the PTAC/Vert-I-Pak unit; ➤ ➤ Remove the thermostat cover; ➤ ➤ Connect the thermostat wires to the supplied Wiring Connector - refer to the Wiring Table to determine proper connections; ➤ ➤ Plug in th ...

ration settings at any time by pressing the “Confi guration” button. 9 Thermostat Confi guration Once the thermostat is powered, thermostat confi guration settings will appear on the thermostat screen. In order to properly operate the PTAC/Vert-I-Pak unit: ➤ Set the thermostat clock; ➤ E ...

Setting the thermostat clock Set the thermostat clock to current time in 24h (Military Time) format. ➤ Use the “Up” and “Down” buttons to set the hours; ➤ Press the “Fan” button to advance to the minutes setting; ➤ Use the “Up” an “Down” buttons to set the minutes; ➤ Press the “F/C” button to advan ...