DMP Electronics XR150 series Lab Manual

Instructor-Led Training IDENTIFY PANEL COMPONENTS 1. Identify the following panel components using the panels in front of you, or the on-screen photo of the XR. ê Reset header ê Programming header ê Outputs ê AC Power terminals ê Cellular pins ê 1100 Series antenna connection ê On-board zone terminals ê Network connection ...

1. Navigate to AREA INFORMATION and press a top- row select area 2. Enter an AREA NUMBER and press CMD 3. Press CMD until EXIT DELAY displays 4. Press a top row select key or area and enter a time between 45 and 250 seconds 5. Press a top-row select area to clear any text and enter in a new area name 6. Exit AREA INFORMATION and navigate to STOP ...

1. At the keypad, press CMD until the USER MENU? prompt displays 2. Select YES and enter 99+CMD to enter the USER MENU 3. Using CMD, navigate to SCHEDULES? and press a top-row select area 4. Select TIMES 5. To create a time schedule, select ADD 6. Press 1 to create Schedule 1 7. Press a top row area to name the schedule ACCESS 8. Press CMD ...

terminal on the panel 5. Connect the other leg of the LED to the second ORANGE wire on the harness 6. Connect the second GRAY wire to the BLACK terminal on the panel 7. Power the panel back up 8. Enter the Programmer by entering 6653 (PROG) at the keypad 9. Navigate to ZONE INFORMATION and press a top- row se ...