extronics iRFID101 Installation And Operating Manual

2 Document Number X120440(3) (Refer to Extronics DDM for release status) Based on type approval document 403431-1.0 The Photograph on the front page shows the iRFID101 Aluminium Enclosure version; a Stainless-Steel version is also available. For warranty information, refer to Terms and Conditions at http://www.extro ...

3 Contents 1 Introduction ................................................................................................... 4 2 Safety Information and Notes ........................................................................... 5 2.1 Storage of this Manual ..................................................... ...

4 1 Introduction The iRFID101 is an ATEX and IECEx approved Zone 1 RFID Reader Enclosure with intrinsically safe RF outputs; it is designed to allow the deployment of RFID readers in hazardous areas. The concept allows installation of equipment from leading RFID Reader vendors such as SICK, CAEN and Impinj, meaning ...

5 2 Safety Information and Notes 2.1 Storage of this Manual Keep this user manual safe and in the vicinity of the device. All persons required to work on or with the device should be advised on where the manual is stored. 2.2 Special Conditions for Safe Use 2.2.1 ATEX/IECEx 1. Contact Extronics for information on th ...

6 Warning! The iRFID101 must NOT be installed in hazardous areas requiring Category 1, M1 or M2 equipment. Warning! Although antennas connected to the Intrinsically Safe RF outputs of the iRFID101 may be installed in hazardous areas requiring Category 1 equipment, the iRFID101 flameproof enclosure must NOT be instal ...

7 Warning! Optical radiation hazards may be present within the iRFID101 enclosure – observe the warning labels fitted. Warning! The iRFID101 may weigh up to 70Kg. Exercise care when handling and mounting. Warning! DO NOT lift the iRFID101 using the threaded entries, N-type RF connectors or door bolts. Lift only us ...

8 3 Installation 3.1 Mounting Warning! The iRFID101 stainless steel enclosure weighs approximately 70Kg. Exercise care when handling, and use suitable mounting points and structures. Mount the enclosure ONLY using the mounting points shown. Warning! DO NOT lift the iRFID101 using the threaded entries, N-type RF conn ...

9 3.2 Opening and Closing the Enclosure Important Ensure that NO TOOLS come into contact with the flamepath of the enclosure, as this may cause irreparable damage and render the unit unsafe. Warning! The iRFID101 flameproof enclosure must NOT be opened when an explosive gas or dust atmosphere is present, or when the ...

10 3.2.2 Closing the Enclosure • Check that the correct grease (Loctite 8104 or Loxeal GS9) has been applied to the flame-path, and that it is free of damage. • Check all bolts are the correct type and free from damage. • Re-insert the bolts and hand-tighten only. • Using a torque wrench fitted with an 8mm h ...