Exmark LAZER Z Setup Instructions

Text of the manual

Page 1 of 5

109-6182 Rev. A Loose Parts Note: Use the chart below to verify that all parts have been shipped. 109-6181 Dealer Pack Part # Description Qty Use 323-6 98-5975 3290-357 Cap Screw, Hex 3/8-16 x 1 Washer, Belleville Nut, Hex Flange 3/8-16 8 8 8 Installing the Rollover Protection System (Roll Bar) 103-1309 Warranty Registration Form 1 Fill out and

Page 2 of 5

109-6182 Rev. A FIGURE 2 FIGURE 3 NOTE: Be sure the spring disk washer cone is installed towards the head of the capscrew. 11. Locate the latch pin assemblies (pin and hairpin connected with a lanyard). 12. Insert a 1/2-13 x 3 1/4 capscrew (removed in step 5) into the bent tab washer on the lanyard of each pin assembly (Fig. 3). Note: Make sure

Page 3 of 5

109-6182 Rev. A FIGURE 4 4. 31 HP Briggs & Stratton units only: a) Route the switch wire from the seat over the top of the front seat frame crossmember. b) Using one of the two wire ties included secure the wire near where the seat hold up rod is connected to the seat frame. c) Using the second wire tie, secure the wire again to approximately the

Page 4 of 5

109-6182 Rev. A CAUTION POTENTIAL HAZARD ♦ If the ignition is in the “ON” position there is potential for sparks and engagement of components. WHAT CAN HAPPEN ♦ Sparks could cause an explosion or moving parts could accidentally engage causing personal injury. HOW TO AVOID THE HAZARD ♦ Be sure ignition switch is in the “OFF” position

Page 5 of 5

109-6182 Rev. A FIGURE 5 FIGURE 6 cubby. Slide it on the air intake hose. Slide the air intake hose onto the carburetor intake. Check to be sure the air cleaner intake hose adequately engages the carburetor intake and the air cleaner elbow. Tighten both wire style hose clamps securely. 5. Locate the inlet rain cap and flat band style clamp in

Other Lawn Mower Manuals