Xantech BYPASS94 Installation Instructions

The BYPASS94 routes Infrared control signals around RF amplifiers and non-DC passing splitters. 10-19-99 Short Coaxial Jumper Cables CPL10 Couplers 3.5/3.5mm Mono Mini Plug Cable IR RF RF/IR CPL10 COUPLER IR RF RF/IR CPL10 COUPLER CPL10 COUPLER IR RF RF/IR IN OUT CPL10 3.5/3.5mm Mono Mini Plug Cable Coaxial cable to IR receivers and TVs RF Amp CPL10 Short Coaxial Jumper Cable Short Coaxial Jumper Cable Coaxial cable from IR controlled RF sources CPL10 COUPLER IR RF RF/IR BYPASS94 Kit Parts The kit includes the following parts: 2- CPL10 RF/IR Couplers 2- Short coaxial jumper cables, with "F" connectors on each end. 1- Connector cable with 3.5mm mono mini plugs on each end. INSTALLATION The following diagram illustrates how to connect the kit parts into a coaxial line to route the IR control signal around an RF amplifier in an RF system. IMPORTANT: Be sure that the IN and OUT terminals of the RF Amp are connected to the terminals marked "RF" on the CPL10 Couplers. Use the same technique to bypass non-DC passing splitters or other RF devices.