Xantech 710-00 Installation Instructions

audio/video components. Used with cordless phones, it provides a control system not affected by sunlight or any other infrared interference. The Fone Link contains an infrared signal lea ...

Link is supplied with a plug-in power supply. Do not plug the power supply into the wall outlet until instructed to do so. In order to program the Fone Link, you will need the hand-held remote controllers for each of the ...

To use the cordless telephone to make calls or to answer calls, do everything as you would do without the Fone Link -- except add the asterisk (*) key to the routine. When you are ready to dial, press the asterisk (*) key first -- this connects you to the telephone line and gives you a dial tone. When you answer the ...

The asterisk (*) key cannot be programmed. Its only purpose is to access the telephone line. It may be pressed at any time, either before or after remote control commands are sent. 3/6 STRETCH CONTROl Although most cordless telephones will continue to send dialing tones (DTMF pulses) as long as keys are pressed, ...

The DELETE LED will blink continuously. 3. Activate the cordless phone (pick-up a wired phone, if used). 4. Press the key on the phone which has been programmed with the command that you wish to erase. The command is erased and the DELETE LED turns off. You may now re-program the key. SHORT COMMANDS Some com ...