Desa BLP100 Owner's Manual

OWNER’S MANUAL Save this manual for future reference. Save this manual for future reference. For more information, visit www.desatech.com For more information, visit www.desatech.com GENERAL HAZARD WARNING: FAILURE TO COMPLY WITH THE PRECAUTIONS AND INSTRUCTIONS PROVIDED WITH THIS HEATER, CAN RESULT IN DEATH, SERIOUS BODILY INJURY AND PROPERTY LOSS OR DAMAGE FROM HAZARDS OF FIRE, EXPLOSION, BURN, ASPHYXIATION, CARBON MONOXIDE POISONING, AND/OR ELECTRICAL SHOCK. ONLY PERSONS WHO CAN UNDERSTAND AND FOLLOW THE INSTRUCTIONS SHOULD USE OR SERVICE THIS HEATER. IF YOU NEED ASSISTANCE OR HEATER INFORMATION SUCH AS AN I ...

For more information, visit www.desatech.com SAFETY INFORMATION WARNINGS SAFETY INFORMATION WARNING: This product contains and/or generates chemicals known to the State of California to cause cancer or birth defects, or other reproductive harm. WARNING: FIRE, BURN, INHALATION, AND EX- PLOSION HAZARD. KEEP SOLID COMBUSTIBLES, SUCH AS BUILDING MATERIALS, PAPER OR CARD- BOARD, A SAFE DISTANCE AWAY FROM THE HEATER AS RECOMMENDED BY THE INSTRUC- TIONS. NEVER USE THE HEATER IN SPACES WHICH DO OR MAY CONTAIN VOLATILE OR AIRBORNE COMBUSTIBLES, OR PRODUCTS SUCH AS GASO- LINE, SOLVENTS, PAINT THINNER, ...

For more information, visit www.desatech.com SAFETY INFORMATION PRODUCT IDENTIFICATION UNPACKING THEORY OF OPERATION • To prevent injury, wear gloves when handling heater. • Never attach duct work to heater. • Do not alter heater. Keep heater in its original state. • Do not use heater if altered. • Turn off propane supply to heater when not in use. • Use only original replacement parts. This heater must use de- sign-specific parts. Do not substitute or use generic parts. Im- proper replacement parts could cause serious or fatal injuries. SAFETY INFORMATION Continued PRODUCT IDENTIFI ...

For more information, visit www.desatech.com PROPANE SUPPLY Propane gas and propane tank(s) are to be furnished by the user. Use this heater only with a propane vapor withdrawal supply system. See Chapter 5 of the Standard for Storage and Handling of Liquefied Petroleum Gas, ANSI/NFPA 58 and the Propane Instal- lation Code CAN/CGA B149.2. Your local library or fire depart- ment will have this booklet. The amount of propane gas ready for use from propane tanks varies. Two factors decide this amount: 1. The amount of propane gas in tank(s) 2. The temperature of tank(s) The chart below shows the nu ...

For more information, visit www.desatech.com TO START HEATER 1. Follow all installation, ventilation and safety information. 2. Locate heater on stable and level surface. Make sure strong drafts do not blow into front or rear of heater. 3. Make sure the control knob is in the OFF position. 4. Plug power cord of heater into a three-prong, grounded extension cord. Extension cord must be at least six feet long, UL/CSA listed, and of a proper size. Extension Cord Size Requirement Up to 100 feet long, use 16 AWG rated cord. 101 to 200 feet long, use 14 AWG rated cord. 5. Plug extension cord into a 1 ...

For more information, visit www.desatech.com TROUBLESHOOTING REMEDY 1. Check voltage to electrical outlet. If voltage is good, check heater power cord for breaks 2. Adjust motor/fan mount to keep fan from hitting inside of heater shell. Bend fan mount if necessary 3. Replace fan. See Fan, page 8 4. Replace motor. See Motor, page 7 1. Repeat installation and operation instructions. See Installation, page 4 and Operation, page 5 2. A) Check ignitor wire. Tighten or reattach loose ignitor wire. See Figure 10, page 8 for ignitor wire location B) Set gap between ignitor electrode and target plate to ...

For more information, visit www.desatech.com SERVICE PROCEDURES MOTOR 1. With heater on its side, remove base tray. 2. Access ground screw through underside of heater base. Re- move ground screw. Disconnect the green motor wire and the green power cord wire from underside of shell (see Figure 5). 3. Remove black and white motor wires from terminal board (see Figure 5). 4. Carefully push motor wires through hole in bottom of shell. 5. Remove screws holding motor mount to shell. Use nut-driver (see Figure 6). 6. Carefully pull motor and fan out of shell. IMPORTANT: Be careful not to damage fan. D ...

For more information, visit www.desatech.com FAN 1 Remove motor, motor mount, and fan (see Motor, steps 1 through 8, page 7). 2. Clean fan using soft cloth moistened with kerosene or solvent. 3. Dry fan thoroughly. 4. Replace fan on motor shaft. Make sure setscrew is touching back of flat surface on motor shaft (see Figure 8). 5. Place setscrew on flat of shaft. Tighten setscrew firmly (40-50 inch-pounds). 6. Place motor, motor mount, and fan guard into rear of heater shell (see Motor, steps 14 through 18, page 7). Motor Shaft Fan Setscrew Figure 8 - Fan, Motor Shaft, and Setscrew Location Figur ...

For more information, visit www.desatech.com SERVICE PROCEDURES SPECIFICATIONS WIRING DIAGRAM ACCESSORIES 7. Check gap between ignitor electrode and nozzle to .13"/.15" (see Figure 12). 8. Test for spark. WARNING: Make sure heater is disconnected from propane supply. Heater could ignite causing severe burns. Plug into extension cord and watch for spark between ignitor electrode and nozzle. 9. Place motor, motor mount, and fan guard into rear of heater shell (see Motor, page 7, steps 14 through 18). Figure 12 - Clearance between Ignitor Electrode and Target Plate Burner Nozzle Gap Area Ignitor ...

For more information, visit www.desatech.com ILLUSTRATED PARTS BREAKDOWN Models BLP100 and REM100LP ILLUSTRATED PARTS BREAKDOWN MODELS BLP100 REM100LP ...

For more information, visit www.desatech.com PARTS LIST MODELS BLP100 REM100LP This list contains replaceable parts used in your heater. When ordering parts, follow the instructions listed under Replacement Parts on page 12 of this manual. PARTS LIST Models BLP100 and REM100LP KEY PART NO. NUMBER DESCRIPTION QTY. 1 102362-01 BaseTray 1 2 M11084-26 HexTPG Screw, 10-16X 38 15 3 103917-01AA Base 1 4 099138-02 Nozzle 1 5 098511-216 Shell Kit 1 6 M11084-29 Hex TPG Screw,10-16 X .75 2 7 M51104-01 Handle 1 8 ** Combustion Chamber Kit 1 9 099538-01 Thermocouple 1 10 099237-01 Thermocouple Cli ...

For more information, visit www.desatech.com TECHNICAL SERVICE You may have further questions about this heater. If so, contact DESA Heating Products’ Technical Service Department at 1-866-672- 6040. When calling please have your model and serial numbers of your heater ready. You can also visit DESA Heating Products’ Technical Service web site at www.desatech.com. REPLACEMENT PARTS PARTS UNDER WARRANTY Contact authorized dealers of this product. If they can’t supply original replacement part(s), either contact your nearest Parts Cen- tral or call DESA Heating Products’ Technical Service ...

For more information, visit www.desatech.com 1. Who will heater be used by? ❍ Individual ❍ Business 2. Will you use your heater in more than one location? ❍ Yes ❍ No 3. Where will the product be used? (You may select more than one.) ❍ Workshop ❍ Barn ❍ Residential Construction ❍ Commercial Construction ❍ Garage ❍ Factory ❍ Recreation ❍ Warehouse ❍ Utility Shed/Outbuilding ❍ Other ______________________________ (Specify) 4. Cost of product (excluding sales tax)? $________________________________ 5. Mainten ...

;e ;;pdl;lklsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl ;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l klsuiejlb oeklhi kokle ,,;log;e ;;pdl;l WARNING klsuiejlb oek ...

For more information, visit www.desatech.com WARRANTY AND REPAIR SERVICE KEEP THIS WARRANTY Model Serial No. Date of Purchase 2701 Industrial Drive P.O. Box 90004 Bowling Green, KY 42102-9004 LIMITED WARRANTY DESA Heating Products warrants this product and any parts thereof, to be free from defects in materials and workmanship for one (1) year from the date of first purchase when operated and maintained in accordance with instructions. This warranty is extended only to the original retail purchaser, when proof of purchase is provided. This warranty covers only the cost of parts and labor requir ...