Cisco LightStream 1010 Series Mount The Chassis

• Unpack and Inspect the Chassis, on page 1 • Desktop-Mount the Chassis, on page 2 • Wall-Mount the Chassis, on page 2 • Rack-Mount the Chassis, on page 5 Unpack and Inspect the Chassis The chassis is thoroughly inspected before shipment. If any damage occurred during transportation or any items are missing, contact your customer se ...

You can mount the chassis on a desktop by placing it on a desk in a horizontal position. Make sure there are no blockages or obstructions within one inch of the top of the chassis or within .5 inches of the sides and back, so that nothing interferes with cooling. Do not remove the rubber feet included with the chassis. They are also ...

• Two Phillips #6 x 1¼ inch screws (part number 48-2289-01) • One anchor #8 wall screw (part number 51-4718-01) Follow these steps to mount your chassis on a wall. Step 1 Choose an orientation (left-, right-, or rear panel-side up) and a location on the wall for the chassis. Step 2 Use a penci ...

Step 4 Use the two #6 x 1¼ inch screws to drill into a stud, or use the anchors (#8 wall screw) from the dry-wall kit to hang it into dry wall. If you are mounting the chassis onto something other than drywall, such as wood or sheet metal, anchors may not be required. Step 5 Drill a hole into the wall a ...

Caution Step 9 To uninstall the chassis from the wall mount, slide the wall-mounted chassis from the wall, and remove the three screws from the bottom of the chassis. What to do next If you are installing a FIPS cover on the chassis, follow the steps in Install t ...

Left cable guide rack tray cutouts 2 Two cable guides (part number 700-122664-01) 1 Six Phillips M3 x 0.5 x 10 mm screws (part number 48-0796-01) 4 Right cable guide rack tray cutouts 3 a) Align the cable guides with the cutouts on the sliding-rack tray flange (see figure above). b) At the rea ...

— Three short black screws M3 x 6 mm (part number 48-0384-01) 1 Step 4 Adjust the position of the chassis and the rack shelf until the three mounting holes in the dimples in the bottom of the shelf are aligned with the mounting holes in the bottom of the chassis. Step 5 Tighten the screws to lock the chassis ...

Velcro straps for power supply 2 Velcro straps for power supply 1 Power supply stop 4 Power supply stop 3 — Rear sliding stop and screw (one of two screws on the sliding stop) 5 a) Loosen the Velcro straps and place the power supply on the rack shelf behind the chassis. Make sure the AC inlet cord faces ...

— Velcro straps tightened over power supply 1 Step 8 Slide the rack shelf into the sliding-rack tray. Figure 8: Slide the Rack Shelf into the Sliding-Rack Tray Step 9 The chassis is now installed in the rack shelf, which is installed in the sliding-rack tray. Repeat Steps 1 through 8 to install a second chassis. Mount th ...

Step 10 Install the sliding-rack tray into your rack using the correct screws (12-24 x 0.75 inch or 10-32 x 0.75 inch) from the rack-mount kit that fit your rack type. You can now attach your power supply cord and run it through the cable guides. What to do next Install the cables according to your default sof ...