AKCP sensorProbe2 Operation & User’s Manual

Copyright © 2020, AKCP Co., Ltd.. ...

- 2 - 1) Introduction 1. What is sensorProbe? 2. What’s the difference between SP2 SP4 and SP8? 3. What’s the difference between SP8 and SP8-X20? 4. How to use this manual 5. sensorProbe2 6. sensorProbe4 and sensorProbe8 7. sensorProbe8-X20 8. sensorProbe8-X20 20 Extra Dry Contact Inputs 2) Installati ...

- 3 - 1) Introduction A. What is sensorProbe? The sensorProbe2, sensorProbe4, sensorProbe8 and sensorProbe8-X20 (SP2/SP8/SP8- X20) are intelligent devices for monitoring environmental variables, power, physical threats and security. The units are IP based and include a web interface for configuration. In ...

- 4 - F. sensorProbe2 Front view of the SP2 Back view of the SP2 The SP2 back view shows intelligent sensor ports 1 and 2. Standard 10/100MB Ethernet Port and the 5VDC power input from the AC power adapter. IMPORTANT NOTE: ALL of our AKCP sen ...

- 5 - SP4 & SP8 LED’s The LED’s on the sensorProbe4 and sensorProbe8 will display a solid green when a sensor is connected and in a normal state. The red LED’s will blink slowly when a sensor goes into a warning state and will blink rapidly when the senor enters a critical state. The red LED’s wil ...

- 6 - G. sensorProbe8-X20 & sensorProbe8-X60 sensorProbe8-X20 Front View The front view above of the SP8-X20 shows the LED’s on the units 8 sensor ports and the 20 extra dry contact inputs. The same description applies to these LED’s as outlined above for the sensorProbe8 unit. The rear view of the SP ...

- 7 - The rear view of the sensorProbe8-X60 shows the 60 dry contact inputs, the 8 intelligent sensor ports, the 10/100 Ethernet port, the 5VDC AC power input jack and the GND ground stud. Extra dry contact input practical applications: The extra dry contact inputs can be used to monitor many types of equ ...

- 8 - 2. A PC with Ethernet card or LAN socket. Make sure you re-configure your PC or laptop’s network IP address to be in the same network subnet of the unit. For example, you can set your laptop’s IP to be 192.168.0.101, 3. AC power socket for the unit to connect to using the 5VDC AC power adapter t ...

- 9 - c) You will now be presented with the following login screen. d) After logging in you will be taken to the main summary page as shown below. ...

- 10 - e) From the summary page select the “Network” tab. After entering your new IP address click “save” Testing your new IP address We now need to test that your new IP address has been assigned successfully. We will do this via the “ping” command. 1. Click start/run…… ...