Aerus Mobile Manual 

READ MANUAL CAREFULLY FOR PROPER PROCEDURES AND OPERATION. 2017 Space Technology Hall of Fame Inductee ...

Important Safety Instructions . . . . . . . . . . . . . . . . . 3 Parts and Accessories . . . . . . . . . . . . . . . . . . . . . . . . . 4 Control Pad Layout . . . . . . . . . . . . . ...

CAUTION: Not for use on 12 volt positive ground or 24 volt vehicles . Doing so may damage the product . WARNING: UV Lamp operation . Do not operate this unit unless the case is completely and correctly assembled . Failure to comply may result in serious eye damage . CAUTION: Do not operate unit near heat sources, open ...

A . WIRE STAND . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9950153 B . BASE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...

of the Velcro to the base, then attach the other to a clean, dry surface, or . . . 1 . Attach suction cups by pressing and twisting into the base, or . . . 3 . Screws may be used for extra security and where the other methods are not appropriate . 1 . If desired, mount the base in an appropriate location (see below) . 2 . Adj ...

surface with or without the base 2 . Hanging over an edge pointing down (laundry hamper, garbage can, etc .) 3 . Sitting on a flat surface without the base 4 . On a vertical surface with the base (wall mount, window, etc .) 5 . Hanging over an edge pointing up (seat pocket in car) The wire stand on the Aerus Mobile allows for quic ...

into an appropriate 12 volt automotive type power outlet . Insert the small adapter plug into the opening located underneath at the rear of the unit . Select and install the proper international plug into the AC adapter . Insert correctly assembled adapter into a standard electrical outlet . THEN NOTE: when installing one of the int ...

slightly, and remove screws at the front of the unit . 2 . With the front remaining tilted up, slide the lower half of the case back and up until it is free . 3 . Lift the small circuit board holding the target screen and bulb (Bulb Assembly) from the two tabs . 4 . Disconnect the leads of the Bulb Assembly from the main cir ...

1. UV Lamp – Do not touch with bare hands . If touched, clean the bulb with a cotton swab and a small amount of alcohol . 2 . Attach ActivePure® Target Screen (a) to the Target Frames (b) . 3 . Install the legs of the Target Frames (b) into the four holes of the Bulb Assembly PC board (c) . 4 . Attach th ...

internal components every one to three months . ActivePure® Target - Clean the target by gently removing dust with a small, soft brush . UV Bulb - The UV bulb should be gently wiped with a soft, dry cloth . Avoid handling the UV bulb more than necessary . Case - Clean th ...