Agio 1031550 Assembly Instructions Manual

ITM. / ART. 1031550 ASSEMBLY INSTRUCTIONS RETAIN FOR FUTURE REFERENCE: READ CAREFULLY BEFORE ASSEMBLY CSA Model 99500 WARNING Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. An LP-cylinder not connected for use shall not be stored in the vicinity of this or any other appliance. DANGER If you smell gas: 1. Shut off gas to the appliance. 2. Extinguish ...

Important Safety Information 3 Important Information About Propane 4 Specifications 4 Parts Identification List 5 Installation 6-7 Natural Gas Conversion 8-9 Batteries 9 Lighting Instructions ...

The installation must conform with local codes or, in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54; International Fuel Gas Code. ; Natural Gas and Propane Installation Code, CSA B149.1; or Propane Storage and Handling Code, B149.2, as applicable. The appliance and appliance main gas valve must be disconnected from the gas supply piping system during any pressure testing of that system at te ...

PROPANE (LP) GAS A LP-gas cylinder for use with this appliance must have a capacity of 9kgs / 20 lbs. and must be equipped with a Type 1 connector and an OPD (overfill protection device). Figure 1 The LP-gas supply cylinder to be used must be constructed and marked in accordance with the specification for LP-gas cylinders of the U.S. Department of Transportation (DOT) or the National Standard of Canada, CAN/CSA-B339, Cy ...

PART DESCRIPTION PART# QTY A CONTROL KNOB FP0245 1 B GAS VALVE FP0307 1 C THERMOCOUPLE FP0004 1 D LP REGULATOR HOSE FP0005 1 E ELECTRODE FP1330 1 F GAS TUBE ZCF0117 1 G ORIFICE ELBOW FP1385 1 H IGNITION MODULE FP0006 1 I ORIFICE BRACKET FP0311 1 J PROPANE ORIFICE CC00C2155 1 K NATURAL GAS ORIFICE ZCF0024 1 L LP TANK RETAINING KNOB FP0585 2 M FIRE ICE SET ZCF0116 1 N ADJUSTABLE FOOT CAPS FC0759 4 O BOLTS HW0142 4 P WA ...

be a minimum of 60.96 cm / 24 in of clearance from the side of the table top to any combustible walls. 2. Place the tabletop on the base. Secure the tabletop to the firepit base using the bolts and washers that are provided. See Figure 3 3. Pour the fire ice into the burner pan completely covering the burner. See Figure 4. 4. Remove the cardboard cov ...

shown in Figure 6. Turn the black handle clock-wise to tighten. Turn the handle counter clock-wise to remove. The hose must point down. Check that the valve is turned all the way clockwise to the "OFF" position. Open the tank valve. Apply a solution of soapy water to the tank-regulator connection and to the valve-hose connection to check for leaks. If soap bubbles ...

Natural gas conversion must be performed only by your natural gas provider or service company. Step 1- At the control panel, disconnect the rubber gas hose from the gas valve. Step 2- Below the burner, disconnect the aluminum gas tube from the orifice elbow. Step 3- Remove the 2 M4 nuts from the orifice holder and remove the orifice bracket assembly. Step 4- Disconnect the orifice from the elbow and replace it with the Natural Gas ...

Metal Rating Plate • • • • • • • Conversion Label BATTERIES Make sure the control knob is in the "OFF" position. Unscrew the push button cap on the ignition module located on the control panel to access the battery compartment. The ignition module requires one Alkaline AAA size battery (1.5V). The negative (-) end goes in first. See Figure 9. Dispos ...

explosion may result causing property damage, personal injury or loss of life. 1. Open the tank drawer and find the control panel on the left. Make sure the control knob is in the "OFF" position. See Figure 10. Open the tank valve all the way. 2. Push in the igniter button. You will hear a slight clicking sound. With the igniter button pushed in, push and turn the c ...

Place the lazy susan / burner cover on the table top as shown in Figure12. WARNING: BEFORE PLACING THE LAZY SUSAN / BURNER COVER ON, MAKE SURE THE FIREPIT HAS BEEN SHUT OFF AND THE BURNER HAS COMPLETELY COOLED DOWN. TROUBLESHOOTING GUIDE PROBLEM CAUSE REMEDY Burner won’t light No Propane Gas at Burner Check that gas tank valve is open. Turn control knob to “ON” and push control knob in. Make sure tank has propane g ...

What is covered under this warranty? Subject to the terms and conditions set forth below, fireplaces are warranted against defects in material and workmanship for a period of one year. If you have questions regarding care and maintenance of the item(s) you have purchased, please see the accompanying care and maintenance guide or visit our website at www.agio-usa.com. If you have further questions, please call our cu ...

following are excluded from coverage under this warranty: any item used for commercial, contract or any other non-residential purpose; display models or items purchased “as is”; freight damage; items subject to misuse, abuse, neglect or lack of proper care or maintenance (including without limitation as provided in any “care and maintenance guide” ...

ITM. / ART. 1031550 INSTRUCTIONS D'ASSEMBLAGE IMPORTANT : GARDER POUR RÉ FÉRENCE FUTURE. LIRE ATTENTIVEMENT LES INSTRUCTIONS AVANT DE COMMENCER L'ASSEMBLAGE. CSA Model 99500 WARNING: Il est DANGEREUX d'utiliser ce produit pour la cuisson! Installateur, laissez ces instructions au consommateur. Consommateur, gardez ces instructions pour référence future. DANGER S'il y a une odeur de gaz: 1. É teindr ...

Informations de sécurité importantes 3 Information importante au sujet du propane 4 Caractéristiques 4 Liste des pièces 5 Installation 6-7 Conversion au gaz naturel 8-9 Piles 9 ...

L’installation doit être conforme aux codes locaux ou, en leur absence, au National Fuel Gas Code, ANSI Z223.1/NFPA 54; à l'International Fuel Gas Code; au Natural Gas and Propane Installation Code, CSA B149.1; ou au Propane Storage and Handling Code, B149.2. L’appareil et le robinet de gaz principal doivent être isolés du système de tuyaux d’alimentation en gaz en fermant la vanne d'arrêt pendant tout e ...

PROPANE (GPL) Une bonbonne contenant du gaz (GPL) doit avoir une contenance de 9 kg (20 lb) pour être utilisée avec cet appareil et être équipée d’un connecteur de type 1 et d’un OPD (appareil de protection de trop-plein). Voir le schéma 1. La bonbonne de gaz GPL utilisée doit avoir été fabriquée et marquée selon les spécifications pour les bonbonnes de gaz GPL de l’U.S. Department of T ...

QTÉ A BOUTON DE CONTRÔLE FP0245 1 B ROBINET DE GAZ FP0307 1 C THERMOCOUPLE FP0004 1 D TUYAU DE RÉGULATEUR GPL FP0005 1 E ÉLECTRODE FP1330 1 F TUYAU D'ALIMENTATION EN GAZ ZCF0117 1 G ORIFICE COUDÉ FP1385 1 H MODULE D’ALLUMAGE FP0006 1 I SUPPORT D’ORIFICE FP0311 1 J ENTRÉE DU PROPANE CC00C2155 1 K ENTRÉE DU GAZ NATUREL ZCF0024 1 L BOUTON DE MAINTIEN DE LA BONBONNE DE GPL FP0585 2 M « GLACE DE MÉTHANE » ZCF0116 ...

position finale. Il faut un espace minimal de 60.96 cm / 24 po entre l'article et tout mur combustible. 2. Mettre le dessus de table sur la base. Attacher le dessus de table à la base avec les rondelles et les boulons fournis. Voir les schémas 3. 3. Déposer la « glace de méthane » dans le bac du brûleur pour le recouvrir complètement. Voir le schém ...

régulateur tel que montré sur le schéma 6. Visser la poignée noire dans le sens des aiguilles d’une montre pour serrer. Tourner la poignée dans le sens contraire des aiguilles d’une montre pour la retirer. Le tuyau doit pointer vers le bas. Vérifier que le robinet est bien tourné à fond dans le sens des aiguilles d’une montre sur la position « Off » (A ...