Dell S2719H Quick Start Manual

Text of Dell S2719H Quick Start Manual

1. Disassembly Procedures:

Step Figure Remark S1.Before disassemble Turn off power, Unplug external cables from product S2.Remove the STAND‐BASE ASS’Y To remove the stand: 1. Press and hold the stand release button. 2. Lift the stand up and away from the monitor. Note: To prevent scratches on the LCD screen while removing the stand, ensure that the monitor is placed on a soft, clean surface.

Use a Philips-head

screwdriver to remove 2 screws for unlocking mechanisms. (No.1~2 screw size=M3x3; Torque=6±1kgf.cm) Use Penknife to separate the bezel and rear cove follow the arrows in sequence, then you can take out rear cover. S4.Disconnect the pins and remove the tapes 1 2

Use a Philips-head

screwdriver to remove 6 screws for remove speaker. (No.1~6 screw size=M3x6; Torque=6±1kgf.cm) Only for S2719H model S6.Remove the mainframe Use a Philips-head screwdriver to remove 4 screws for remove mainframe (No.1~4 screw size=P3x4; Torque= 3±0.5kgf.cm) S7.Remove the middle frame Use a Philips-head screwdriver to remove 14 screws for remove middle frame (No.1~14 screw size=M3x3; Tor

S8. Remove the

panel FFC cable and the converter board to panel cable S9.The panel

Use a Philips-head

screwdriver to remove 5 screws for remove main board and converter board (No.1~5 screw size=D3x6; Torque=6±1kgf.cm) 1 2 3 4 5

(height < 25mm,

diameter< 25mm) S14.The Main Frame

2. Product material information

The following substances, preparations, or components should be disposed of or recovered separately from other WEEE in compliance with Article 4 of EU Council Directive 75/442/EEC. Capacitors / condensers (containing PCB/PCT) No used Mercury containing components No used Batteries No used Printed circuit boards (with a surface greater than 10 square cm) Product has printed circuit boards (with a

Dell Monitor Owners Instructions: