Aiphone IS-IPRY Programming Manual

• MAC Address Label Overview / Description 2 Package Contents The IS-IPRY is a Barix Barionet 50 with proprietary firmware installed for the device to function with the Aiphone IX Series, IS-IP Series stations, Relay outputs can be programmed to trigger for door release, upon call-in, while in ...

A. Log in to the IX Series system using the IX Support Tool. B. Expand the Function Settings tree on the left and select SIF Integration. C. Choose the station to be edited from the Number drop down menu then click the Select button. D. Select the Enable radio button for both the CGI Integration and SIF Integration. Click ...

Upload the SIF.ini file to each IS-IP Series station associated with the IS-IPRY adaptor. ! Note that the IP address for each station will be unique for your network settings. Important: The intercom system must be fully programmed and operational prior to uploading the SIF.ini file. A. Open a web browser and type ht ...

Relay status and control. Click on each LED to verify relay function. Digital input status Configuration button The IS-IPRY has a default IP address of 192.168.1.45. Open a web browser and point the address bar to http://192.168.1.45 for access to the adaptor. The first screen to appear will be ...

communicating with a specific station. The relays can also be programmed for door release. Set the IS-IPRY for use with the IX Series (refer to page 5). From the DEVICE CONFIGURATION screen, click APPLICATION SETUP. APPLICATION SETUP butto ...

The IS-IPRY adaptor has 4 inputs that can be programmed to trigger a call-in from a specific door station or master station to a specific master station or group of master stations. The IS-IPRY inputs can have different calling rules than the default calling rule set during the IX Series programming. Select the call-in priority ...

Enter the IP address and TermID for each IS-IP station in the IS configuration. This table is used as a reference for each TermID in the system. After inputting each IP address and TermID, click Apply Settings at the bottom of the page to save the settings to memory. Return to the Application Screen or reboot adaptor by clicking the ...

communication, but only when a “configured” master station pushes the door release button. When the relay action is set for any of the “Active While” options, the relay will trigger when the associated door station calls or ...

Click on Destinations next to the input being configured. A new window will open. Enter the TermID for each master station to be called (see page 8 for TermID information). A maximum of 20 master stations TermID’s can be entered. Check the Enable box beside each TermID entered to allow the master to be called. Onc ...