Adaptivation WIRELESS PAL PAD Instruction Manual

ADAPTIVATION I N C O R P O R A T E D 2225 W. 50th St., Suite 100 1-800-723-2783 Sioux Falls, SD 57105 PRINTED IN U.S.A. ...

INTRODUCTION ................................................... 3 THEORY OF OPERATION .................................... 3 TERMINOLOGY .................................................... 4 MODES OF CONTROL ......................................... 5 WIRELESS PAL PAD DIAGRAM ........................ 6 BATTERY INSTALLATION ............. ...

signed to provide access for individuals with physical or mental disabilities to basic environmental control. The Wireless Pal Pad will allow one electrical appliance or bat- tery operated device to be activated. The Wireless Pal Pad uses an RF signal to remotely operate either an X-10 po ...

through walls unlike infrared which requires line of sight. Wireless Receiver A Wireless Receiver will allow the Wireless Pal Pad to control most battery operated devices and also communication aids or other assistive devices. ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ...

less Pal Pad and will allow activation of most electrical or AC appliances. House Code The house code is the frequency the Wireless Pal Pad uses to transmit to either a Wireless Receiver or a Transceiver Mod- ule. The house code must be set to the same letter on both de- vices. ...

Unit Code Dial Mode Selection Switch Delayed Activation Switch OFF L D H 1 9 13 5 ...

Pal Pad should last several years. Please call Adaptivation before replacing the battery. 1. With the Wireless Pal Pad lying face up, carefully lift up the battery cover tab. Do not bend the tab any more than needed to remove the battery. 2. Place a pointed tool in the slo ...

activated into another Appliance Module set to a different unit code. 2. Plug the appliance you wish to operate into the bottom of the Transceiver and plug it into the wall outlet. Make sure the appliance is in the "on" position. 3. Check to make sure the wattage of the appliance does not ex ...

ceiver and it is turned on. 3. Insert the plug on the Wireless Receiver into the battery operated device you wish to activate. 4. Set the Wireless Pal Pad to the desired mode of control. 5. Press the top of the Wireless Pal Pad to activate. Options: If you are activating a communication ai ...

sponding device activates almost immediately. A one second delay can be added. This means the Wireless Pal Pad must be held down for one second before the device will operate. This can be very helpful for a person who may accidentally drag their hands. Delayed activation wil ...