ABB KSONIK MICRO Operation Instruction Manual
Text of ABB KSONIK MICRO Operation Instruction Manual
Ultrasonic Level Transmitter
Operation instruction manual OI/KMICRO-EN Rev. B
Ultrasonic level measurement
with GAP technology
K-TEK Products
Introduction
This operation instruction manual provides the following
information:
–
Quick start instructions for distance, level and flow - see
page 3
–
Installation procedures - see page 6
–
Ins
2 KSONIK MICRO Ultrasonic Level Transmitter | Operation instruction manual
Table Of Contents
1.0 Introduction .............................................................................................................................................................3
2.0 Quick Start for Distance.........................................................
Operation instruction manual | KSONIK MICRO Ultrasonic Level Transmitter 3
The KSONIK MICRO works on the non-contact principle of ultrasonics.
A pulse of energy emits from the Transducer at the speed of sound and
is detected on its return. The Transmitter can distinguish the difference
between the correct echo and other ambient noise. When the signal
retur
4 KSONIK MICRO Ultrasonic Level Transmitter | Operation instruction manual
3.0
Quick Start for Level
1.
Connect up the power to the instrument described on the KSONIK MICRO face label or in the KSONIK MICRO
manual under terminal connections on page 51.
2.
Press
3.
Use to get to the default security Code 5159 and
Operation instruction manual | KSONIK MICRO Ultrasonic Level Transmitter 5
5.0
Changing Parameters
Step 1
Simply press
The SECURITY CODE prompt should be displayed.
Step 2
Enter the code 5159 by pressing the keys
Step 3
To confirm security code press
Dist. 2.000 m
mA Output:
7.20 mA
Instant:
2.000 m
Temperature:
20°C
Percentage:
20.00%
SCROLL
6 KSONIK MICRO Ultrasonic Level Transmitter | Operation instruction manual
If Code has been accepted, the screen will display
If Code has not been accepted, the screen will display
If the security code has been changed and forgotten then contact the nearest K-TEK agent for override code.
To carry on with programming go to page 16.
6.0
INSTALLATION
The KSON