Bard Q24H2-A Installation Instructions Manual

INSTALLATION INSTRUCTIONS Bard Manufacturing Company, Inc. Bryan, Ohio 43506 www.bardhvac.com Manual No.: 2100-601B Supersedes: 2100-601A Date: 10-30-14 Q-TEC SERIES PACKAGED HEAT PUMP Models: Q24H2-A Q24H2-B Q24H2-C Q30H2-A Q30H2-B Q30H2-C Q36H2-A Q36H2-B Q36H2-C Q42H2-A Q42H2-B Q42H2-C Q48H2-A Q48H2-B Q48H2-C Q60H2-A Q60H2-B Q60H2-C ...

CONTENTS Getting Other Information and Publications For more information, contact these publishers: ........... 3 Q-Tec General Information Q-TEC Model Nomenclature......................................... 4 Shipping Damage ......................................................... 7 Unit Removal From Skid ................... ...

GETTING OTHER INFORMATION AND PUBLICATIONS These publications can help you install the air conditioner or heat pump. You can usually find these at your local library or purchase them directly from the publisher. Be sure to consult current edition of each standard. National Electrical Code ...................... ANSI/NFPA 70 St ...

TABLE 1 FACTORY BUILT-IN ELECTRIC HEAT TABLE (See Table 2 for Available Electric Heat by Unit Model) Nominal KW At 240V  At 208V  At 480V  At 460V  KW 1-Ph Amps 3-Ph Amps BTUH KW 1-Ph Amps 3-Ph Amps BTUH KW 3-Ph Amps BTUH KW 3-Ph Amps BTUH 5.0 5.0 20.8 17,065 3.75 18.0 12,799 6.0 6.0 14.4 20,478 4.50 12.5 15,359 ...

MODEL Rated Volts & Phase No. Field Power Circuits Single Circuit Dual Circuit  Minimum Circuit Ampacity  Maximum External Fuse or Ckt. Brkr.  Field Power Wire Size  Ground Wire  Minimum Circuit Ampacity  Maximum External Fuse or Ckt. Breaker  Field Power Wire Size  Ground Wire Size Ckt. A Ckt. B Ckt. A ...

SHIPPING DAMAGE Upon receipt of equipment, the carton should be checked for external signs of shipping damage. The skid must remain attached to the unit until the unit is ready for installation. If damage is found, the receiving party must contact the last carrier immediately, preferably in writing, requesting inspection by th ...

HANDLING UNIT AFTER REMOVAL FROM SKID The unit will have to be turned sideways and removed from the skid to fit through a 36" doorway. If the door height allows, the unit can be slid sideways through the door. If the unit cannot be slid through the door, then the unit will have to be put on a cart and tipped down to roll throug ...

FIGURE 6 DUCTED APPLICATION FIGURE 5 INSTALLATION WITH DUCT FREE PLENUM ...

DUCT WORK Any heat pump is more critical of proper operating charge and an adequate duct system than a straight air conditioning unit. All duct work must be properly sized for the design airflow requirement of the equipment. Air Conditioning Contractors of America (ACCA) is an excellent guide to proper sizing. All duct work o ...