Sunbeam SB08 Operating Instructions Manual

Operating Instructions Model No. SB08 Read all instructions carefully before using this item SMT122911 ...

1. Needle Clamp 2. Bobbin Compartment 3. Needle 4. Take-up Lever 5. Tension Screw 6. Thread Spindle 7. Bobbin Holder 8. Hand Wheel 9. On/Off Switch 10. Speed Button 11. Battery Compartment 12. DC Jack 13. Foot Pedal Jack 14. Presser Foot Lever 15. Bobbin Winder 1. Make sure the OFF before inserting batteries. 2. Put 4 AA ...

1. Raise thread spindle by pulling it upward until it’s fully extended. 2. Place thread spool on the thread spindle. (for bobbin spindle: pull out the spindle and guide it through the hole in the bobbin and replace the spindle) 3. Pull the thread from the spool through the first thread guide (1) in the direction toward front of mac ...

clockwise direction. 2. Raise the presser foot by lifting up on the lever in back of the machine above the presser foot bar. 3. Position fabric to be sewn under the presser foot with presser foot in raised position. Make sure seam direction is aligned with the presser foot, with ...

2. Loosen the needle clamp screw by turning it counter clockwise. You may need to use a short slotted screwdriver or small piece of metal (e.g. dime). 3. Remove the needle, pulling down, away from the needle clamp. 4. Place the new needle with the flat side facing in against the ne ...

needles or threading machines  Never open the main motor case of the machine. The mechanism has been factory adjusted.  Always check the threading of the lockstitch before beginning to sew a seam. Improper threading or placement of the bobbin will result in damage to the mac ...

purchase against defects in material and workmanship. During this period such defects will be repaired, or the product will be replaced without charge. This warranty does not cover damage caused by misuse, negligence or improper installation. Warranty is also invalid in any case tha ...