Summer 27990 Instruction Manual

INSTRUCTION MANUAL Please read the following instructions carefully. Keep this instruction manual for future reference. Tools required: Phillips head screwdriver, drill (for top of stair installation), and pencil (not included), wrench (included). For use with children from 6 - 24 months. Keep small parts away from children. Adult as ...

Large Extension Frame C D Lower Latch Top Latch E Adhesive Mounting Pads (4) H Wall Anchors (4) Wall Cups (4) I J Screws (4) K L Wrench M Tension Bolts with Tension Nuts (4) Extension Pins (4) F G Door Stopper N C D B 2 E A F N hardware: G x4 x4 H I J K L x4 x4 x4 x4 M x1 FALL HAZARD! IMPORTANT! KEEP ...

Measure the width of the opening where you intend to install the gate. Refer to the following illustrations to determine the correct installation configuration. Baseboard molding may change which configuration is appropriate. A B C (28.5˝- 30.5˝) without extension frames (31.5˝- 34.25˝) with sma ...

into upper and lower holes on both sides of extension frames (or gate frame if no extensions are being used). H x4 1 G x4 x4 Connect the extension frames to the gate frame by inserting the extension pins into the holes in the extension frame, or into the gate frame (if extensions are not being used). ...

distance between the gate and the wall should never exceed 2.75”. IMPORTANT Use the tension nuts to tighten both of the bottom tension bolts. 4 3 5 Use the tension nuts to tighten both of the top tension bolts. A B Stand the gate in the center of the opening. Make sure the bottom of the gate is complete ...

the entire outline of each tension bolt directly onto the wall. Loosen the lower and upper tension nuts and remove gate. STOP! wall cup/top of stairs installation: WARNING For use at top of stairs, wall cup installation is MANDATORY. Follow these wall cup installation instructions when using gate at TOP OF STAIRS (MANDATORY), ...

drywall, follow this step and use the wall anchors provided. ! x4 Mark drill holes with a pencil through the center of each wall cup. Mark drill holes with a pencil through the center of each wall cup. x4 Place a wall cup over the center of each circular outline on the wall. Place a wall cup over the center of each circ ...

the back of each wall cup. peel peel 2nd 3rd Remove backing from one side of each adhesive mounting pad. Remove backing. 1st 10 Align the wall cups so the center hole is placed directly over the wall anchor. Stick wall cups to the wall. Make sure all wall cups are facing up. Make sure all wall cups are facing up. wall cup/top of stair ...

The 4 tension bolts will rest within each wall cup. x4 wall cup/top of stairs installation (continued): 12 13 9 L NEVER open gate door over stairs. IMPORTANT: ...

tension nuts with the provided wrench. wall cup/top of stairs installation (continued): x4 14 10 FINISHED! Note: This gate includes a door stopper which prevents the gate door from swinging open in one direction when used at the top of the stairs. ! When mounting this product at the top of the stairs, locate the door stopper ...