STEINBAUER 220181 Installation Manual

Text of STEINBAUER 220181 Installation Manual

The Emotion of M otion

Installation Guide Power enhancement Iveco Eurostar 470 EDC 13.6 Euro 2 345 kW

STEINBAUER Tuning Technologies is an innovative manufac-

turer of electronic components and additional modules for the worldwide vehicle market. Our aim is to supply you with results, not only products. Thank you for choosing to buy from STEINBAUER. T h e E m o t i o n o f M o t i o n . w w w . s t e i n b a u e r . c c

STEINBAUER 220181 NOTE: Usage of our products causes the expiry of the

INT 08/06 w w w . s t e i n b a u e r . c c Important information To be able to take the benefits of all technical advantages of your newly purchased STEINBAUER Additional electronic, please consider the following advices. Do not use the STEINBAUER Additional electronic before you have read and understood the “Important information”. The installation confirms that the buyer has read, understood and

Plugging in, simple method

Put the wire of the ECU into the notch of the cable clip and close it. HINT! Press together with a pair of pliers! Then connect the cable clip to the flat connector. Soldering, perfect method As the copper wires may corrode due to humi- dity, it would be better to solder the wires.

STEINBAUER Power enhancement

Reference signal wire Air pressure sensor STEINBAUER Power enhancement Electronic pedal sensor Reference signal wire INT 04/06 NOTE: Usage of our products causes the expiry of manufacturer´s warranty. w w w . s t e i n b a u e r . c c Connection via “Electronic pedal sensor”, alternative method Solder the reference signal wire on the wire of the electronic ped

STEINBAUER Additional electronic without cover

Connector Wiring loom Potentiometer Symbol A B LED Stop 0% 100% tweleve o´clock 100 % totally right 130 % totally left 50 % w w w . s t e i n b a u e r . c c INT 04/06 NOTE: Usage of our products causes the expiry of the manufacturer´s warranty. Fine adjustment of the STEINBAUER Additional electronic Due to original tolerances of manufacturing the preset characteristic map of the STEINBAUER Additional electr

Battery Negative (-)

terminal (chassis ground) You can order the switch separately. Part no. 200086. You can order the remote control separately. Part no. 200089. STEINBAUER Additional electronic STEINBAUER Switch Power enhancement Original power LED Battery STEINBAUER Remote Control Wires for power supply STEINBAUER Transmitter Switch wire STEINBAUER Additional electronic Switch wire Switch Installation Connect the grey wire of the switch to the Switch

w w w . s t e i n b a u e r . c c

All our deliveries are made on the basis of our following sales and delivery conditions. Modifcations or additional agreements need to be confirmed in writing to be valid. This General Terms & Conditions are available in English and German. In case of any divergence between the two versions the German version shall prevail. Other purchasing conditions of the buyer is hereby rejected; you do not commit ourselves, not even i

STEINBAUER 220181 The E m o t i o n o f M o ti on .

HEAD QUARTER: STEINBAUER Tuning Technologies Austria GmbH Neu Gablonz 5 4470 Enns T: +43 / (0)7223 / 811 75-0 F: +43 / (0)7223 / 811 75-40 E: [email protected] USA 08/08 Subject to change. Copyright © 2008 STEINBAUER Tuning Technologies. All rights reserved. Design and Concept © STEINBAUERMEDIA.com

STEINBAUER Automobile Accessories Owners Instructions: