Star CS511 Instructions Manual

MODEL #CS511 Español p. 10 Serial Number Purchase Date Questions, problems, missing parts? Before returning to your retailer, call our customer service department at 1-800-742-5044, 7:30 a.m. - 5:00 p.m., EST, Monday - Friday. ATTACH YOUR RECEIPT HERE SW1014 B ...

2 C Hose Strainer 1 D Motor Brushes 2 Please read and understand this entire manual before attempting to assemble, operate or install the product. • NOTE: Pumps with the “UL” Mark and pumps with the “US” mark are tested to UL Standard UL778. CSA certif ...

Before installing this product, have the electrical circuit checked by an electrician to ensure proper grounding. All electrical installations must conform to the National Electric Code and all local codes. • ELECTRICAL SHOCK ALERT. Connect this product to a properly-grounded 115 volt circuit equipped with a Ground Fau ...

package contents list. If any part is missing or damaged, do not attempt to assemble the product. Estimated Installation Time: 10 minutes Tools may be required for assembly: Crescent wrench, PVC-safe pipe sealant or thread sealant tape. • PERSONAL INJURY O ...

source, and strainer (C) should be used at the end of the inlet line. NOTE: Make sure the inlet hose is NOT coiled or kinked above or below water level. The inlet line may be galvanized pipe, plastic pipe, or reinforced hose. Be sure there are no leaks in the inlet line, as this may reduce p ...

(A) outlet. A standard 3/4 in. garden hose may be used as a discharge line. Keep the total length as short as possible for best performance. In Out 2 A PRIMING AND STARTUP 1. Remove priming plug from the top of pump (A). 2. Fill pump (A) housing with clean water. Reinstall plug. DO NOT RUN DRY. NOTE: Do ...

cord to grounded outlet. Pump (A) will prime in a few minutes, depending on suction line length. Unplug pump (A) to turn it off. 3 A 4. If the pump does not pump water after five minutes, turn off the pump and repeat steps 1 through 3. DO NOT RUN DRY. 4 A How to Replace Brushes NOTE: Motor brushes ...

begin pumping or retain prime after operating, or stops pumping water. 1. Air leak in suction line. 1. Repair or replace suction line. Make sure fittings are air tight and use thread sealant tape if necessary. 2. Fittings are not tight. 2. Tighten fittings air tight, using thread s ...

025059 C Hose strainer 025058 D Motor Brushes 015846 E Priming nut 025060 F Impeller, shaft seal and volute kit 024512 WARRANTY REPLACEMENT PARTS LIST Printed in China There are no warranty replacement parts available for this product. For non-warranty replacement parts listed below, call our customer service ...