Stack-On PC-1702-RFID Instruction Manual

Text of Stack-On PC-1702-RFID Instruction Manual

40720-1702 1 16

Instructions PC-1702-RFID Tools Required: Drill Flat Head Screwdriver 10 mm Wrench 3/16” (5 mm) drill bit for drilling into wood Hardware Included: (2) M6 x 20 mm (3/4” long) Screws (2) Washers (2) Plastic anchors ® Your Electronic Combination: Serial #: IMPORTANT NOTE: You can store your Key #, Serial # and Combination on Stack-On’s SECURE website – stackon.com under Customer Service. Storing your Key # or Combination will provid

INSTALLING THE BATTERIES

When you first receive your case you will need to open the cover with the key in order to install the batteries. Batteries are included and are located inside the case. Pull the foam upward and away from the battery compartment. Remove the battery compartment by pushing the tab and pulling the compartment out as shown. Install (4) AAA alkaline batteries which are included. Reinstall the compartment by hooking t

Hold RFID device approximately ¼” over the

over RFID button . Two “beeps” will sound (if the sound is turned on) and the panel will flash green twice and open. If RFID is not programmed, the Red light will flash and beep 3 times (if the sound is turned on). ge USING THE RADIO FREQUENCY IDENTIFICATION DEVICES (RFID) Press the Reset Button (3) located inside the case. Two “beeps” will sound (if the sound is turned on) and panel will �

• For security you must program your own

combination after opening the case. • Record your new combination on this form or store your combination on our secure website at stackon.com under Customer Service. If you write down your combination you must keep this information in a secure place, away from children, not inside the case. USING THE ELECTRONIC COMBINATION Enter your combination using the buttons. The buttons will light up green and there will

SECURING THE CASE WITH THE CABLE

For optimal performance while on the go, the case should be installed in an isolated, dry and secure area. NOTE: This case can be secured with a cable that is attached to a fixed object. Failure to to do so will compromise the safety and security of the case. To secure the case to a fixed object, loop the cable around the object and place the cable’s small end into the notch on the side of the case. Tip the cable end d

TURNING THE KEYPAD SOUND

OFF/ON Your case comes with the "Beep" sound turned on. You can turn off the "Beep" sound of the keypad by pressing RFID button and holding for 3 seconds until the panel flashes green then purple. To turn the "Beep" sound on, press the RFID button and hold for 3 seconds until the panel flashes green then purple. CLEARING ALL CODES Clearing the codes will erase the signature of the programmed RFID devices and the program

RFID Device or Key Request

“This is not a Registration Form” Verification of ownership is required in order to receive replacement RFID device or key for your security product. In order to receive a replacement RFID device or key to your security product: 1. Complete the following form and send to Stack-On Products. 2. Send a copy of your valid driver’s license along with the form. 3. Send a copy of the receipt showing the original purchase. 4. Secur

LIMITED ONE YEAR WARRANTY

STEEL CABINETS AND SECURITY CASES Stack-On Products Co. (“Stack-On”) Steel Cabinets and Security Cases, are warranted to be free from defects in material and workmanship for a period of one (1) year from the date of original purchase by a consumer. This warranty extends to the initial consumer only. If you believe there is a defect in material or workmanship in your Steel Cabinet or Security Case, during the one-year warran

Stack-On Safes Owners Instructions: