Spectrum XDS560v2 Installation Manual
Text of the manual
XDS560v2 System Trace JTAG Emulator for CCS 4.x
Quick Start Installation Guide
Kit Contents
+5V Universal
Power Supply
XDS560v2
System Trace
AC Power
Cords
Ethernet Cable
Driver DVD
MIPI60 – 20CTI
MIPI60 – 20ARM
MIPI60 – 60TI
MIPI60 – 14TI
System Requirements
•
Microsoft Windows™ 2000/XP/Vista
•
2 GB of free hard disk space
•
Installing the Code Composer Studio software
1.
Code Composer Studio should be installed before
starting the hardware installation. Please refer to the
Code Composer Studio software installation guide for
the installation of Code Composer Studio. The
baseline Spectrum Digital emulation drivers are
included in CCS v4.2 and higher and these should be
installe
The figure below shows the Ethernet or USB cable,
power cord plugged into the XDS560v2 STM.
6.
Now connect the tail of the emulator to the JTAG
header on your target board. If your target board
requires a different interface than the generic 60 pin
header on the tail, attach one of the header adapters
as required.
Caution should be used in the routing
512106-4001B Page 4 of 4
12502 Exchange Dr., Ste 440, Stafford, TX. 77477 T:281.494.4505, F:281.494.5310 www.spectrumdigital.com
