Directed Electronics G4203X Owner's Manual

Text of the manual

Warning! Safety first..........................................................................................7

What is Included .............................................................................................9 Important Infor

© 2008 Directed Electronics. All rights reserved.

Government Regulations This device complies with Part 15 of FCC rules. Operation is subject to the fol- lowing two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. This equ

Warning! Safety first

The following safety warnings must be observed at all times: Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. When properly installed, this system can start the vehicle via a command signal from the remote control transmitter. Therefore, never operate the system

© 2008 Directed Electronics. All rights reserved.

After the remote start module has been installed, contact your authorized dealer to have him or her test the remote start module by performing the Safety Check outlined in the product installation guide. If the vehicle starts when performing the Neutral Safety Shutdown Circuit test, the remote start unit h

© 2008 Directed Electronics. All rights reserved.

What is Included The control module • Two 1-button transmitters • (P/N 7211X) A push-button programming switch • Your warranty card • A shut-down toggle switch • Important Information Congratulations on the purchase of your remote start keyless entry sys- tem. This system has been designed to pr

© 2008 Directed Electronics. All rights reserved.

➢ Battery Replacement Front Elastomer contact Front Elastomer contact Front Circuit Board Front Elastomer contact Front Elastomer contact Using a small slotted screw- 1. driver, insert into slot located on the side of the unit as shown and carefully pry the front of the unit up, working your way around t

© 2008 Directed Electronics. All rights reserved.

Using Your System ➢ Unlocking Only after the vehicle is remotely started via the transmitter, press and release the transmitter button for 1 second to unlock the vehicle’s doors. The remote responds with 2 short beeps and the green LED on the re- mote flashes once. The vehicle responds by flashing the

Other Automobile Electronics Manuals