Sony CBK-SD01 Installation Manual

To reduce the risk of electric shock, fire or injury, do not perform any servicing other than that contained in the operating instructions unless you are qualified to do so. Refer all servicing to qualified service personnel. ! WARNUNG Die Anleitung ist nur für qualifiziertes F ...

1. Installation 1-1. CBK-SD01 Configuration.....................................................................1-1 (E) 1-2. Applicable Models for Installation........................................................1-1 (E) 1-3. Installation Procedure............................................................................1-1 ( ...

. DIF-147 board (1) . B2 x 4 (2) . Precision screw P1.4 x 3.5 (2) . Installation Guide (1) . Installation Manual (1) In addition to the Installation Manual, the following manuals are available. . PDW-510/510P/530/530P Operation Manual (Supplied with PDW-510/510P/530/530P) Th ...

Panel Opening the Inside Panel n Be sure to turn off the POWER switch, unplug the AC power cord or remove the battery before starting the following procedure to prevent the inside of the unit from damage. 1. Loosen the four screws (with drop-safe) and open the inside panel in the direction of the arrow. m ...

1. Confirm that both of the right and left hinges are engaged with the hooks of the chassis correctly. 2. Attach the inside panel and fix it with the four screws (with drop-safe). n Standard tightening torque value : Screw (with drop-safe, B3 x 12) 0.8 N.m (8.0 kgf.cm) n Be careful not to pinch the harness between th ...

147 board) to the connector (CN2) on the DCP-36 board (the DCP-32 board for MSW-900/900P) and fix it to the supports with the two screws supplied. n Standard tightening torque value : Screw P1.4 x 3.5 0.1 N.m (1.0 kgf.cm) Screw B2 x 4 0.19 N.m (1.9 kgf.cm) 3. Connect a coaxial cable that is ...

Select the output signal following the steps as shown below. Identifying switches 1. Turn on the main power. 2. While pressing the rotary encoder, set the MENU ON/OFF switch to ON to open the TOP menu. 3. Select the OPERATION menu and press the rotary encoder. 4. Select the OUTPUT display and press the rotary encode ...