Solo SGK-10 Assembly Manual

Assembly Manual Copyright © 2011 Solo Music Gear - All rights reserved ...

4 3 1b 1a - Threaded hex bushings (6 pcs, 6 flat washers included) 1b - Tuning machines (6 pcs, 6 mounting screws included) 2 - Truss Rod Cover (3 mounting screws included) 3 - Neck 4 - Strings (6 pcs) 5 - Top Pickguard Plate (2 mounting screws included) 6 - Strap Buttons (2 pcs, 2 mounting screws included) 7 - Neck Pickup on ...

Assembly Manual Thank you for purchasing a Solo DIY guitar kit. This unfinished guitar kit has everything for building an SG style electric guitar – you will need only some basic tools and finishing supplies. All challenging wood cutting, drilling and shaping is already professionally done, as well as fret leveling and dressing. ...

instructions. If you are using a metal clamp be very careful not to damage the wood of your guitar – use some pieces of wood on both sides to protect it. STEP 3 – There are many different ways to apply finish to your guitar. Do a little research to decide which typ ...

controls and B500 (Linear Taper) for Tone controls. Some musicians, however, like it better when linear pots are used for volume and audio are used for tone (and some guitar manufacturers use   only one Audio type for both controls). STEP 6 - After you complete the wi ...

the 12th fret: .063” – .078” (1.6 - 2mm). For the 6th String (the thickest) – height at the 1st fret: 0.016” – 0.024” (0.4 – 0.6mm); at the 12th fret: .078” – .01” (2 – 2.5mm). The height at the first fret can be adjusted by cuttin ...

them to us for potential posting into the picture gallery on our website. Email it in a JPG format to [email protected] © 2011, Solo Music Gear ...

Black - GROUND Wire Soldering point Wires not connected Neck PU 3-Way PU Selector Switch Bridge PU Volume (Neck PU) Volume (Bridge PU) Ground wire (to the Tail Piece ) CAP CAP Tone (Neck PU) Tone (Bridge PU) . . . . . . SOLO SGK-1 Wiring Diagram Jack Copyright © 2011 Solo Music Gear - All rights reserved vr 1.01 ...