Solar SB40 Installation Manual

www.solar-vision.ca [email protected] T. 1-819-729-0450 1.1 FACTORS AFFECTING AUTONOMY: The bollard must be installed in an open area without nearby structures or dense vegetation that could favor solar module shading. Please make sure that the distance between the bollard and the elements (e.g. fences, bushes, trees, posts, build- ings or structures) is sufficient to avoid the long shadows created by the low winter sun. Use a compass to determine the sun’s path and reduce shading effects. Other factors affecting autonomy are: sunshine below the monthly averages, very low ambient temperature, snow accumu- lation ...

www.solar-vision.ca [email protected] T. 1-819-729-0450 STEP 1 Installation instruction of the anchor bolts for the mounting base: Using the bolt pattern at the end of this document, adjust anchor bolts so there is 1” thread length above the concrete pour top line in order to properly accept the bollard mounting base. Important: Align the bolt pattern parallel to the path as shown in figure 1. STEP 2 Bollard mounting base installation Place the mounting base onto the bolts and use the supplied 3/8” hardware (flat washer, lock washer and nut) to secure in place. Note: Anchor bolts or expansion bolts are not supp ...

www.solar-vision.ca [email protected] T. 1-819-729-0450 STEP 3 Battery padding and battery Place the supplied battery padding and the battery into the mounting base as shown in the figure. STEP 5 Complete the installation Place the bollard main body assembly over the mounting base, as shown in the figure, and use the supplied hardware to secure into place. Important: Make sure not to pinch the battery cable or connector. Make sure to properly clear the battery terminal boots protectors when sliding the main body part over the base. Note: The ventillation vents should be on the opposite side to the path. STEP 4 Batt ...

ANCHOR BOLT X4 4.70 4.70 ALIGN PARALLEL TO THE PATH A A B B 2 2 1 1 WEIGHT: 0 SB40-02 JFOL 15 MAY 19 SB40 ANCHOR BOLT PATTERN PROPRIETARY AND CONFIDENTIAL THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OFSOLAR VISION. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION OF SOLAR VISION IS PROHIBITED. COMENTAIRES: SHEET 3 OF 3 Q.A. MFG APPR. ENG APPR. CHECKED DRAWN DATE NAME DIMENSIONS ARE IN INCHES TOLERANCES: ANGULAR: 1 TWO PLACE DECIMAL 0.6" THREE PLACE DECIMAL 0.31" HOLES: 0.05" DO NOT SCALE DRAWING MATERIAL: REV. A DWG. NO. SIZE SCALE:1:1 FINISH: PLEASE SELECT “ACTUAL SIZE” IN YOUR PRINT MENU F ...