ZORA P1 Manual 

1. Orbbec Pi P2（A311D-4G-01 ）Introduction of Development Board Interface............. 3 1.1 Front picture of development board................................................................................ 3 1.2 Back picture of developm ...

1.1 Front picture of development board 1.2 Back picture of development board 1.3 Introduction to hardware interface processor Amlogic, Quad A73+ Dual A53 ...

Storage-Micro SD Up to 128Gb MIPI-CSI 1 CSI + 8M HDR ISP MIPI-DSI Support USB 2xUSB 3.0 + 2xUSB 2.0 + 1USB XHCI OTG 2.0 HDMI HDMI 2.1 Wifi/BT WIFI 2.4/5G 802.11a/b/g/n/ac, 2x2 MIMO，BT5.0 10m Ethernet RJ45 GigE Vision POE Pin + Extra Cap Microphone On-board PDM PDM interf ...

TX（01） RX GND S_M0 S_M1 S_CS S_CK GND I_MCK I_SCK I_LR I_DO GND GPIO1 GPIO2 GPIO3 GPIO4 GND PWM2 5V 5V SDA SCL SDA2 SCL2 GND P_D1 P_D0 P_SY P_CK GND GCLK 32K GND GPIO5 GPIO6 GPIO7 GPIO8 GND PWM1 3.3V 3.3V（42） 1.5 Uart introduction（from 01 to 04） 3.3V（01） RX TX GND（04） 1.6 PMD introduction（fr ...

There are three ways to enter burn mode: 2.1 Long press “update” button enter burn mode a．Long press update button ...

d.Successfully linked the burning software。 2.2 Use hardware interface uart-debug enter burning mode: a. Using USB to UART serial port tool connect the UART-debug interface b. Through serial protocol tool software ,type in “reboot” c. When the development board is restarted，Press enter continuousl ...

a. Power on the development board by connecting the power adapter b. Open the computer CMD console c. Connecting computer and development board with the otg interface d.CMD console type in “adb reboot update “ e. Successfully linked the burning software ...