PulseAudio PAV140 Manual 

Text of PulseAudio PAV140 Manual 

pulseaudio1.com | vanco1.com | 800.626.6445

40 Watt Single Channel AMPLIFIER PART NUMBER PAV140 Compatible with 70V/100V speakers and systems

1. Do not install or place this unit

in a built-in cabinet, or other confined space without adequate ventilation. 2. To prevent risk of electrical shock or fire hazard, due to overheating do not obstruct unit’s ventilation openings. 3. Do not install near any source of heat, including other units that may produce heat. 4. Do not place unit near flames. 5. Only clean unit with a dry cloth. 6. Unplug unit during lightning storms or when not used for an e

The PulseAudio PAV140 is an amplifier that produces 40 Watts with Class-D

power that is able to output 70V or 100V. Features two stereo inputs (3.5mm jack for line in and (2) RCA for L&R), one digital input and one balanced MIC input, with integrated ducking functionality, EQ control, and MIC mixing. The MIC input supports three levels with condenser MIC, dynamic MIC and line level audio input. The single output channel supports up to 40W @8ohms and is a

Input Selection Button (Toggle)

2. EQ Selection Button (Toggle) 3. Rotary Settings Dial 4. Volume/Level control (can be pushed to mute audio) 5. Power Indictor: Turns red when power is on 6. Microphone Input Port: 3-pole captive screw connector for microphone input; the dial switch on the right side is to select the mirco input kind, including 48V (for condenser microphone), MIC (for dynamic microphone) and LINE (for line audio) 7. Audio Inputs: 3.5mm

Ensure power is off or removed from the PAV140

2. Connect an analog (3.5MM stereo or dual-RCA) and/or digital (optical) audio cable between the audio output of the source device and the appropriate audio input 3. IF USING A MICROPHONE: Move the MIC Input Switch to the appropriate setting and connect using the 3 conductor phoenix connecter based on the type of microphone being used a. 48V – 48dB gain with 48V phantom power: When the switch turns to

Switching the audio input to input 1

A: 1 2A1. Switching the audio to input 2 90Wx2 3A1. Switching the audio to input 3 180W 0A0. Mute audio of MIC and line out Mute 1A0. Mute audio of MIC Mute MIC 2A0. Mute audio of line out Mute line 3A0. Enable noise gate Gate on 4A0. Disable noise gate Gate off 0A1. Unmute audio Unmute audio 600% Checking the working status A: 1 Volume of MIC: 50 Volume of line: 50 Bass

The letter inside bracket [ ] is the variable code, which is able to be changed

2. The bracket [ ] is not included to the actual RS232 commands 3. Any dot “.” after the letters is part of the commands 4. ID coding: • The ID codes of 40 Watt Power Amplifier ranges from 0 to F (hexadecimal), when sending RS232 commands, please take notice of the address of the ID code • If the address of the ID code is 0, any RS232 command is available �

PulseAudio Amplifier Owners Instructions: