DLS IRIDIUM 10 Manual 

Text of DLS IRIDIUM 10 Manual 

DLS IRIDIUM 10 Connection in mono bridge mode with an active x-over. Voice

coils connected in series. If you have a 1 ohm stable amplifier the voice coils should be connected in parallel for best performance (for example on a DLS monoblock). Connected with a 12 dB passive low-pass x-over = 10 mH coil in series and a bipolar capacitor of 3

Technical specifications for DLS ULTIMATE Iridium 10

Iridium 10 Size 25 cm (10") Impedance 2 x4 ohm Nom. power (RMS) 500 W (max 800) Frequency range 25 Hz - 2,5 kHz Voice coil, diameter 75 mm (3”) Voice coil, length 40 mm (1,57”) X-max +-14 mm (0,55”) Cms 128,96 SD 346 cm2 Cone material Non-press paper Magnet weight 180 oz (5,1 kg) Magnet, diameter 180mm (7,08”) Installation depth 133 mm (5,24”) Mounting hole 236 mm (9,29”) Outer diameter 264

RECOMMENDED ENCLOSURES FOR Iridium10, Iridium12 & Iridium15

VENTED BOX Sub Connection Volume (litre/ft3) Port Damping F3 Fb Ir.10 VC in series 29 / 1,02 3” x 30 cm/11,8” Line inside 33 Hz 34,0 Hz Ir.12 VC in series 29,6 / 1,05 3” x 16,5 cm/ 6,5” Line inside 43,9 Hz 43,0 Hz Ir.12 VC in parallel 39,65 / 1,4 3” x 18 cm / 7,1” Line inside 36,6 Hz 35 Hz Ir.15 * 50 / 1,765 4” x 31 cm/12,2” Line inside 38,3 Hz 37,0 Hz * voice coils either in serie

HINTS & TIPS FOR ”DO IT YOURSELF” ENCLOSURE BUILDERS

ABOUT THE RECOMMENDED ENCLOSURES The performance of these recommended enclosures will vay from vehicle to vehicle. It is more difficult to get a tight and well defined bass in a SEDAN vehicle because of the tightness between trunk and interior of the vehicle. In this case a band- pass box could

DLS Other Owners Instructions: