Xylem Lowara GHV1 Operating, Installation And Maintenance Instructions
Read Online
Read the Xylem Lowara GHV1 Operating, Installation And Maintenance Instructions online using the built-in PDF viewer.
Key Pages of Document
GHV1-4 Hydrovar Variable Speed 1 Operating, Installation and Maintenance Instructions EC Declaration of conformity Xylem Water Solutions UK Limited declare that the GHV Booster set conforms to the requirements of the Machinery Safety Directive 2006/42/EC. Electromagnetic compatibility (EMC) Directive 2014/30/EU Conforming t ...
2000F 2 Identification code Series 10 = 1 pump 20 = 2 pumps 30 = 3 pumps 40 = 4 pumps Set WRAS approval M = Single phase Set supply T = Three phase No digit above 2.2kW Three phase Pump type & motor supply Installation The cold Water booster set is despatched mounted on a wooden pallet and covered in a protective film, it is recomm ...
Connect the incoming water supply to the break tank ball valve. The outlet of the tank will already be connected to the booster set suction manifold. The tank will generally include a class AB air gap (Category 5 protection) the tank will also include a low level float switch connected to the booster set to protect against dry running ...
All Hydrovar sets are fitted with slow fill controls to help prevent excessive pressures being excreted on system pipe work when the set comes back on line after a power outage or low water condition. Slow fill operation When the set powers up or comes back on line after a low water condition it will automatically inhibit all pumps except pu ...
Volt free Change/over contacts are available for Run & fault conditions for each Hydrovar. See electrical drawing for connection details. Remote inhibit A remote normally closed contact can be used to remotely inhibit the booster set. (open to inhibit) See electrical drawing for connection details. Caution This booster set is an automati ...
1. Check all pumps produces the correct pressure. 2. Check that the pump operates without undue noise or vibration. 3. Check the break tank is clean and that the correct water level has been maintained. 4. Check that all screws are tight on electrical components. 5. Check that the earth connect ...
Millwey Rise Industrial Estate, Axminster, Devon EX13 5HU - UK Tel: 01297 630230 Fax: 01297 630270 e-mail: [email protected] www.lowara.co.uk www.xyleminc.com Lowara is a trademark of Xylem Inc. or one of its subsidiaries. © 2016 Xylem, Inc. Lowara reserve the right to make modifications without pri ...
