Siemens CGV Installation Operation & Maintenance

Text of the manual

(Supercedes all previous issues of ANIM-03535)

©2014 Siemens Industry, Inc. All rights reserved. Installation Operation Maintenance Large Frame Vertical 680, 800, 1120 Frames Types CGV, CGHS, CGIIV, CGIIHS, CGGV, CGGHS, CAZV, CAZHS, CAZBV, CAZBHS Induction Motors/ Generators

- 1 -

Table of Contents Page Page TABLE OF CONTENTS 1 OPERATION 11 SAFETY PROCEDURES 2 Initial Start 11 INTRODUCTION 3 Out of Service/Storage 11 Warranty 3 Normal Operation 12 Receiving 3 Trouble Shooting 13 Handling 4 MAINTENANCE 15 Temporary Storage 4 Preventive Maintenance 15 Description 4 Inspection 15 Type Designations 4 Correc

- 2 -

Safety Procedures This equipment contains hazardous voltages. Death, serious personal injury or property damage can result if safety instructions are not followed. The successful and safe operation of motors and generators is dependent upon proper handling, installation, operation and maintenance, as well as upon proper design and manufacture. Failur

- 3 -

Introduction DANGER Hazardous voltage. Will cause death, serious injury, electrocution or property damage. Disconnect all power before working on this equipment. These instructions present general recommendations for installation, operation and maintenance of induction motors built at the Norwood plant. If additional information is required, contact

- 4 -

Introduction WARNING Heavy equipment. Improper handling may cause death, serious injury or property damage. Check lifting devices before lifting. Use proper slings, chains and spreaders. Note any warning plates on motor and follow instructions on each plate. Handling Lifting devices are provided for handling only. An experienced rigger should be used

- 5 -

Installation NOTE The information contained in this book is intended to assist operating personnel by providing information on the general characteristics of the purchased equipment. IT DOES NOT relieve the user of the responsibility of using accepted engineering practices in the installation, operation and maintenance of this equipment, and complying

- 6 -

Installation Hollow Shaft Motors The motor should be set on its base first, and the driven shaft inserted through the hollow shaft. There are times, however, when these motors are lifted and lowered over the driven shaft. In either case, do not cause damage to the shaft by bending or scraping the threads. Proceed as follows: 1. Remove coupling cover

- 7 -

Installation Changing Direction of Rotation Look for rotation plates usually mounted on opposite drive end of the motor. CAUTION Excessive heat. Motor may overheat if motor cooling fans run in the wrong direction. Run motor in direction shown on motor or change fans. NOTE If open or enclosed units have non-reverse ratchets and rotation is changed, the

Other Engine Manuals