Da-Lite MULTI-MASK IMAGER Instruction Book

Text of the manual

DA-LITE SCREEN COMPANY, INC.

3100 North Detroit Street Post Office Box 137 Warsaw, Indiana 46581-0137 Phone: 574/267-8101 800-622-3737 Fax: 574/267-7804 http:// www.da-lite.com e-mail: [email protected] POWER PRESENTATION PRODUCTS The In Instruction Book for MULTI-MASK IMAGER

IMPORTANT SAFETY INSTRUCTIONS

When using your video equipment, basic safety precautions should always be followed, including the following: 1. Read and understand all instructions before using. 2.Position the cord so that it will not be tripped over, pulled, or contact hot surfaces. 3. If an extension cord is necessary, a cord with a current rating at leas

Professional mounting techniques should be adhered to. Da-Lite Screen Company cannot be liable for substandard or

faulty installations. Frame Assembly Assembly of the screen should be in a clean environment. 1. Connect the four frame pieces by matching the colored tapes on the ends of the frame pieces. See Figure 1. 2. Secure with the supplied 5/16" setscr

Unpacking and unrolling the screen

The viewing side of the screen surface is rolled to the inside. The screen surface is rolled lengthwise. 1. Remove screen from packaging. 2. On a clean floor, unroll the screen surface viewing side up. 3. Allow the paper to unroll between backside of the screen surface and floor. See Figure 3. CAUTION: • Be careful not

Electrical wiring is required for each mask roller motor. The vertical masking systems have one motor at the frame top.

Horizontal masking systems have one motor at the frame top and one at the bottom. A motor requires standard 120V/220V input. All connections are made to the electrical box on the audience left side of the unit.

MULTI-MASK IMAGER INSTALLATION

DOWN RED UP BLACK COMMON WHITE BLACK WITH YELLOW BLACK WHITE RED UP DOWN ROCKER SWITCH AC COMMON AC HOT OPERATING SWITCH, SWITCH BOX, AND PLATE FURNISHED WITH SCREEN. (SPDT WITH CENTER OFF) 120V. 60-HZ 2.5 MAX. AMP TO MOTOR IN MULTIPLE CONTROL INSTALLATIONS THIS SWITCH IS REPLACED BY THE LOW VOLTAGE CONTROL, OPERATED FROM PUS

HANGING THE SCREEN ON THE WALL

Attach the wall brackets to the wall using appropriate fasteners at previously marked locations. Attach the Side Covers to the frame by sliding the Bolts on the Side Cover tube into the openings on the top and bottom brackets. See Figure 7. FIGURE 7 OPERATING THE MASK When you lower or retract a mask, it will stop at its pres

Modifying the extension of the mask

You can increase the extension of a mask up to 3" past the factory preset stop, or you can decrease the extension by approximately 4-6" from the factory preset stop. Do not attempt to modify a mask extension beyond these recommended amounts. The limit switches are accessed through openings located on the left side of the

With reasonable care, you expect many years of trouble-free use of your Da-Lite projection screen.

We encourage you to keep your screen clean. Avoid getting any foreign material on the screen. It may not be possible to remove scratches, paint, ink, etc. General maintenance The screen surface on your Multi-Mask Imager is delicate. Special attention to these

Refer to the following guidelines if you encounter a difficulty in the operation of your Da-Lite Multi-Mask Imager screen.

Problems related to electrical or motor function may require a qualified service person or electrician. Should you have a problem that is not addressed here, call the Da-Lite Screen Company. TROUBLESHOOTING SYMPTOM 1. Mask won’t oper

Other Projection Screen Manuals