Point Mobile PM90 Operation & User’s Manual

and battery cover. Unauthorized personnel are strictly prohibited from disassembling the phone. Make sure to use only the power adapter (5V 2A Output AC/DC) that came with PM90. In case your phone does not work as expected, you are strongly recommended to restart it by pressing and ho ...

Table of Contents ............................................... 3 1 Accessary ............................................. 5 2 Setup PM90 .......................................... 6 2.1 Remove the Battery Cover ......................... 6 2.2 Insert the Battery ................................... 7 2.3 Close the Battery Cover ........ ...

1 Display, Touch panel 9 Power button 2 Receiver 10 Earphone cover 3 Front camera 11 Rear camera 4 Buttons 12 Speaker 5 Scan window 13 Battery cover 6 Volume button 14 Battery cover locker 7 Left scan button 15 USB port cover 8 Right scan button 16 Charging cradle connector ...

Micro USB C Type Cable AC plug (US/EU/UK) Battery (2900mAh) Battery (5800mAh) Stylus Wrist landyard LCD protection film ...

2.1 Remove the Battery Cover 1. Slide the Battery locker. 2. Lift up the Battery Cover. 3. Remove the Battery Cover. ...

Insert “Battery” from top area. 2.3 Close the Battery Cover Insert “Battery Cover” from top area first and then put in bottom area. Press battery cover with both hand firmly. ...

You must insert your SIM card to make phone calls. Please power off your phone before inserting or removing the SIM card. 1. Remove the Battery Cover and the Battery. 2. Lift up the SIM rubber. 3. Insert the SIM-SAM card into the slot. (Gold plate should face down). Make sure that it is correctly inserted. 4. To remov ...

1. Remove the Battery Cover and the Battery. 2. Lift up the SIM rubber. 3. Insert the microSD card into the slot (Gold plate should face down). 4. To remove the microSD card, repeat step1 and step2, then remove the card out of the slot. Note: To avoid data loss and SD card damage, please power off your phone before i ...

1. Connect the AC/DC adaptor to your device and wall socket respectively. 2. LED indicator will display charging status. Steady Red Battery is charging or Battery level is low Blinking Red Battery level is critical low Steady Green Battery is fully charged PM90 Battery Specification Standard Battery 2,900mAh 3.85V Backup Battery 5,800mAh 3.8 ...