Sharp HT-SB150 Operation & User’s Manual

Text of the manual

The Bluetooth® word mark and logos are registered trademarks owned by Bluetooth

SIG,. Inc. The terms HDMI, HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc.

Important safety instructions

CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN Please, read these safety instructions and respect the following warnings before the appliance is operated: The lightning fl ash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the prod

• This product does not contain any parts that are serviceable by the user. In case

of a fault, contact the manufacturer or authorised service department. Exposing the internal parts inside the device may endanger your life. The manufacturers guarantee does not extend to faults caused by repairs carried out by unauthorised third parties. • Do not use t

• If the batteries leak, wipe away the leakage inside the battery compartment and

replace the batteries with new ones. • Do not use any batteries other than those specied. Do not ingest battery, chemical burn hazard • If the battery is swallowed, it can cause severe internal burns in just 2 hours and lead to death. Keep new and used batteries away f

• 1x Remote control

• 1x User guide • 1x Quick start guide • 1x Warranty leafl et • 1x UK power cord • 1x EU power cord • 1x Set of wall-mounting screws • 4x Silicone feet • 2 x AAA battery Controls 1 2 3 4 5 1. Display screen 2. Remote sensor 3. Standby – Switch the unit be- tween ON and STANDBY mode. 4. Source – Select

or disconnect the existing paired

Bluetooth device. 3. – Select the play function. 4. VOL +/- – Increase/decrease the volume level. 5. / – Skip to previous/next track in Bluetooth mode. 6. – Play/pause/resume playback in Bluetooth mode. 7. – (MUTE) Mute or resume the sound. 8. BASS +/- – Adjust bass level. 9. TRE +/- – Adjust treble lev

1. Drill 2 parallel holes (Ø 6mm) in the

wall. The distance between the holes should be 650 mm. – Firmly fi x one dowel into each hole in the wall and then insert screws into them. 2. Leave a 4mm gap between the wall and the screw’s head. Lift the unit with the attached wall brackets over the heads of the screws and slot into pl

A. Use a RCA to 3.5mm audio cable (not

included) to connect the TV’s audio output sockets to the LINE IN socket on the unit. B. Use a 3.5mm to 3.5mm audio cable (not included) to connect the TV’s or external audio device headphone socket to the LINE IN socket on the unit. TIP: When you use the headphone output on the TV set, you will be able

4. Press the +/– button to adjust the

volume to your desired level. TIP: While in HDMI ARC/OPTICAL mode, if there’s no sound output from the unit, you may need to activate PCM signal output on your source device (eg. TV, DVD or Blu-ray player). Bluetooth Operation Pair Bluetooth-enabled Devices The fi rst time you connect your Bluetooth device to this

Other Home Theater System Manuals