weha T 800 Quick Start Manual

Vacuum-Lifter T 800 name vacuum – lifter serial # year built typ T 800 suction cup mm 700 x 300 mm air pressure 5 - 6 bar air requirement 120 Ltr. / min. Questions or item orders please direct by phone, in writing or by email to the Weha-Ludwig Werwein GmbH. ...

Please note carefully the information about the use of the machine or device! Caution! Risk of injury! Improper use leads to physical damage! The device or machine is specially designed for one or more applications out. The following chapters aim to introduce these applications in more detail and point out the dangers in d ...

- vacuum-lifter T may only be operated by appropriately authorized persons. Each operator must have read and understood this documentation - before each use check the bearing parts and welds for damage! For the shortcomings in the operation of the vacuum-lifter is set T and the use by third must be prevented by suitable me ...

- Protect the unit or the machine from the weather, such as rain water, sunlight, moisture, etc.! - Ensure the separation of the various materials in the disposal that they can be fed into the recycling loop! The vacuum lifter T has been manufactured in accordance with the general provisions in mechanical engineering. The ...

Be sure to check before mounting the package if all required parts are present. Refer to the dealer or manufacturer if the delivery is not complete. The package includes: • 1 x Vacuum Lifters T • 1 x Operating and Instruction Manual The vacuum lifter T is delivered to you and assembled. An assembly of the individual pa ...

• Make sure that no vacuum loss occurs. If a vacuum loss, the stone slab cannot be transported. The sealing lip and the bearing surface shall be checked and it must again be generated vacuum. During another failed attempt of vacuum lifters T is to undergo an examination, whether this is in perfect working condition. • ...

This inspection must be performed at least once a year. • Check the vacuum lifter T annually rusty bodies, in particular all welds. • Remove the rust and protect this site by applying a suitable rust inhibitor, z. B. Zinc spray. • Check all fittings of the vacuum lifter T for looseness and tighten the screw if necess ...