VDC Electronics BatteryMINDer 12248 Instructions Manual

Text of the manual

® Model 12248

Charger / Maintainer / Desulphator-Conditioner VDC Electronics, Inc. 147 D Woodbury Rd. Huntington, NY 11743 www.vdcelectronics.com [email protected] ob^a�^ka�p^sb�qebpb�fkpqor`qflkp Rev. G-061606 P/N VDC12248-MNL-F

TABLE OF CONTENTS

SAFETY INSTRUCTIONS..........................................................................................................3 PREPARING TO CHARGE.........................................................................................................5 CHARGER LOCATION.........................................................................

Underwriters Laboratories (UL)

REQUIRED SAFETY INSTRUCTIONS WARNING TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSON, OBSERVE THE FOLLOWING: 1. Do not expose charger to rain or snow. It is designed to operate ONLY INDOORS. 2. USE of any attachment not specifically recom- mended by the battery charger manufacturer for use with this exact model

To reduce risk of battery explosion, follow these

instructions and those published by the battery manufacturer and the manufacturer of any equipment you plan to use in the vicinity of the battery. Review cautionary markings on the products and the engine. 8. PERSONAL PRECAUTIONS when working with or near a lead acid battery. a. Someone should be able to hear

NEVER CHARGE A FROZEN BATTERY OR

ONE AT A TEMPERATURE ABOVE 123° F. PREPARING TO CHARGE a. If necessary to remove battery from equipment to charge. Always remove ground ter- minal first. Turn off all accessories in the vehicle, so as not to cause an arc. b. Be sure area around battery is well ventilated while battery is being charged. Force gas vapors away

DC CONNECTION PRECAUTIONS

a. Connect and disconnect DC output clips from battery only after removing charger power cord from outlet. b. Attach clips to battery posts and twist or rock back and forth several times to make good con- tact. This tends to keep clips from slipping off terminals and reduces risk of sparking. FOLLOW THESE INSTRUCTIONS WHEN BAT- TERY

Do not connect clip to carburetor, fuel lines,

or sheet metal body parts. Connect to heavy gauge metal part of frame or engine. h. When disconnecting charger, discon- nect charger from AC outlet, then remove clips from vehicle chassis, and battery posts. Operating instructions for charge information. FOLLOW THESE STEPS WHEN BATTERY IS OUTSIDE OF VEHICLE OR E

QUALIFYING YOUR BATTERY:

Preliminary Requirements NOTE: The BatteryMINDer has no electrical output unless it is connected to a healthy bat- tery. Testing the BatteryMINDer with a volt or an Amp meter without the unit being connected across a good battery will result in a false read- ing. If you experience any problems, or are not sure of how to properly us

condition where the battery can be expected to

function normally. 3. Refill each cell with distilled water only to the liquid level indicator found in each cell. Before proceeding further you must be thoroughly familiar with the safety and operating instruc- tions. 4. Recharge the battery with the BatteryMINDer to ensure that it is slowly and completely char

Con’t. on next page

**Testing with a Hot/Cold Calibrated Hydrometer Tester Read the tester instructions carefully for most accurate readings. 1. When using the tester the first time or after a long period of non-use, fill the tester with the battery fluid and let it sit for 1/2 hour or l

More VDC Electronics Battery Charger Owners Instructions: