Sealey SPB80T.V2 Quick Start Manual

Text of the manual

80kg tow behind broadcast spreader

mODEL NO: spb80t.V2 thank you for purchasing a sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNING

Original Language Version

© Jack Sealey Limited 5. asseMblY step 1: In the following order put flat washer Ø16, wheel spacer, second flat washer Ø16, tyre, third flat washer Ø16 on the end of wheel axle. Insert the cotter pin Ø4x40 into the small hole on the axle and bend to secure. Rotate the wheel so that the hole on the inside of the wheel is aligned

Original Language Version

© Jack Sealey Limited step 6: Attach the two upper braces on each sides of the gauge and lever assembly using hex bolt M6x45 and nylon lock nut M6. Loosely tighten. Connect the other four ends of the braces to the upper mounting tube using bolt M6x45 and nylon lock nut M6. Tighten all fasteners. step 7: 1. Align all the six holes a

step 9: Attach the support rods to the hopper using the hex bolts M6x20, big flat washers Ø6 and nylon lock nuts M6. Adjust sliding plate to

closed position. step 10: Insert the hopper screen into the bottom of the hopper. 5.1. 5.2. step 11: Connect hitch bracket to hitch tongue using drive pin Ø9x60. Hitch tongue is length adjustable, refer to fig.12. ste

sealey group, kempson way, suffolk business park, bury st edmunds, suffolk. ip32 7ar

01284 757500 01284 703534 [email protected] www.sealey.co.uk enVironMent protection Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is

Other Spreader Manuals