Sealey VS403.V2 Instructions

Text of the manual

� Keep this product in good working order and condition, take immediate action

to repair or replace damaged parts. � Use approved parts only. Unapproved parts will invalidate the warranty. � Keep children and unauthorised persons away from the work area. � Keep work area clean and tidy and free from unrelated materials. � Ensure the

4.2 Analysing engine Mechanical condition via Manifold

vacuum Readings The gauge readings shown on the right hand side of this page are only examples of what may be observed. It is important to remember that it is the action of the needle rather than the actual reading that is more important. Varying engine types will run different

4.3 Ignition system vacuum Advance

on standard points systems and some electronic ignition systems there are two types of advance methods used, both of which must function correctly to obtain maximum performance and fuel economy. The first method Is Mechanical or centrifugal, which operates by the use of weights located in the base of the d

4.8 Testing vacuum Operated Heater Taps

Climate control ventilation systems are becoming very common on newer vehicles and most of the systems use vacuum operated taps to control the heating modes. on the majority of makes and models, the system uses vacuum to turn the heater tap 'on'. To test these remove the supply line from the tap vacuum module and conne

Testing Brake servo Diaphragm

remove vacuum supply line from brake servo fitting. Attach VS403.V2 vacuum tester to vacuum supply port on servo (fig.15). operate pump to create approximately 15 inHg of vacuum and wait for 30 seconds. no vacuum drop should be observed on the gauge reading. If the vacuum drops this indicates that the brake s

Other Diagnostic Equipment Manuals