Pike Evolution Series Operator's Manual

Text of Pike Evolution Series Operator's Manual

PSL2021 issue 2 rev a

T5 • PT5 • PT4+ This guide covers Evo T5, PT5 and PT4+ controllers in their standard dual-channel plus newer MULTI channel versions. Please see page 13 for important information.

Evo panel layouts

3 Installation 5 Setting up the signal heads 5 Preparing for operation 6 Setting slaves 6 ...Vehicle 7 ...Pedestrian 7 Setting the master 8 ...Switching on 8 ...Vehicle phases 9 ...Pedestrian 10 ...Starting operation 11 Performing a test start 11 Pedestrian only installations 12 Linking phases 12 Radio channels 13 When mixing Multi-channel and standard controllers 13 Using the scan option 13 Discovering

HE Evo series from Pike Signals delivers a breakthrough

in combined vehicle and pedestrian phase control within portable systems. Drawing upon our long history within vehicle control dating back to 1932 and particularly our pioneering work with high-reliability radio-linked computerised systems, the Evo series is so named because it represents a natural, yet hard fought evolution to be the best. The best for reliability, the best f
Evo panel layouts Evo controllers are highly compact and yet offer full master and slave capabilities. POWER Press and release to switch on, press and hold for two seconds to switch off (see page 6). RUN Press to begin (master or slave) operation (see page 11). Operation mode As master, selects the main operation mode for the system as a whole (see page 11). Text display section Shows setup details, timings and error codes. The arrow and SELECT buttons a

Evo panel layouts (continued)

In addition to the main Evo PT5 controller, the Pike Signals Evo range also offers these other complimentary panels: Evo T5 The Evo T5 controller has all of the controls and capabilities of the Evo PT5 shown on the previous page, except for the pedestrian crossing functions. Evo PT4+ The Evo PT4+ companion controller can be linked to any Evo PT5 to add a further four vehicle phases plus another pedestrian phase supporting up

Setting up the signal heads

1 Set up the signals with the appropriate traffic management scheme for the prevailing roadwork site conditions. Recommended references The latest issues of: •� ‘The�use�of�vehicle�actuated�portable�traffic�signals’� (the�‘Pink�Book’) •� ‘Safety�at�street�works�and�road�works’� (the�‘Maroon�Book’) •� ‘Traffic�signs�regulations�and�general�

Setting slaves (Vehicle and/or Pedestrian)

1 Press POWER to switch on. The text display will briefly show PIKE SIGNALS and then*: •� To�choose�radio channel 01 (the usual choice), go straight to step 2 below. •� To�choose�a�different�radio channel, press . The text display will advance through the available channels (either 1 and 2 for a standard unit or 01 to 17 for a MULTI controller). After 17, the display may show SCAN (see the lo

...Setting slaves (cont.) - Vehicle

4 Press or to scroll through the various vehicle slave signal designations: e.g. Slave Veh 1S, Slave Veh 1D, Slave Veh 2S, Slave Veh 2D... See below for an explanation of the designations. As you scroll through the head designations for the phases, the mimic display for the current phase will show red, amber and green on either the left side or the right side of the mimic, to highlight the Single or Dual head designa

Pike Controller Owners Instructions: