Duerkopp Adler 195 Service Manual

Text of the manual

General safety instructions

Service Manual Cl.195 1. General . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 1.1 Adjustment Aids . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

Thread Trimmer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .

37, 38 2.18 Setting the Edge Cutter 2.18.1 Changing the Knife Stroke . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 39 2.18.2 Setting

The work described in the Service Manual may on be conducted by

duly authorized or approriately trained personnel ! Caution Risk of Injury ! When repairing, converting or doing maintentance work turn off the main switch and disconnect the machine from the pneumatic supply. Adjustments and function testing on the running machine are to

The machine head is equipped with adjustment aids which make

possible a quick and precise setting of all elements. To these adjustment aids belong the handwheel with the letters A, B, D, E and F, as well as the built-in adjustment disc with 5 different holes. The individual setting positions are set with an timing pin. It is included in t

Set of Gauges

The adjustment gauges listed as follows make a precise setting and testing of the machine possible. The timing pin no. 3 is included in the package accompanying every machine. It allows the handwheel positions A to F necessary for settings to be locked in. Gauge Order no. Setting 1 - Gauge 195 002962 - Setting the left lower shaft bearin

Setting the Machine Head

2.1 Adjustment Disc to the Arm Shaft Crank The slot A in the adjustment disc must be aligned with the groove 2 in the arm shaft crank. Only in this position are all other settings to be made with the adjustment disc correct. Caution Risk of Injury! Turn off main switch before adjusting. – Place adjusting pin 3 of the gauge set t

Setting the Lower Timing Belt Pulley

The screws of the lower timing belt pulley should be in the position shown when the machine is arrested in position F. Caution Risk of Injury! Turn off main switch before adjusting. – Arrest the machine in position F. – If the screws are out of position first set the position of the upper timing belt pulley (Chapt

Needle Bar Link

2.3.1 General Information The 195 is equipped with a split needle bar link. The fixed part of the needle bar is screwed directly to the cast body. The second part with the transport foot bar is attached moveably. The screw 1 with yellow paint and secured against turning with adhesive must lie on in the arm. The guide bolt 2 (in the link)

Setting the Link Holder

The link holder 6 must be parallel to the lower edge of the arm head. Caution Risk of Injury! Turn off main switch before adjusting. – Set the screws 4 so that the link holder is parallel to the lower edge of the arm head. 6 4 11

Other Sewing Machine Manuals