Sauder 422197 Manual 

Prefer the phone? Call 1-800-523-3987. Share your journey! sauder.com NOTE: THIS INSTRUCTION BOOKLET CONTAINS IMPORTANT SAFETY INFORMATION. PLEASE READ AND KEEP FOR FUTURE REFERENCE. English pg 1-19 Français pg 20-22 Español pg 23-25 Lot # 505854 07/06/17 Purchased: _________ ...

Assembly Tools Required Part Identifi cation Hardware Identifi cation Assembly Steps Français Español Safety Warranty No. 2 Phillips Screwdriver Tip Shown Actual Size Hammer Not actual size Skip the power trip. This time. 2-3 4 5-19 20-22 23-25 26 27 422197 www.sauder.com/services Page 2 Now you know our ABCs. Part Identifi cation å ...

å Screws are shown actual size. You may receive extra hardware with your unit. 422197 www.sauder.com/services Page 4 23M LIFT TABLE MECHANISM SET - 1 SUPPORT BRACKET - 2 37G NUT - 8 24M WASHER - 8 13M BLACK 9/16" LARGE HEAD SCREW - 16 1S CAM COVER - 8 12P 7F TWIST-LOCK® FASTENER - 10 SCREW COVER - 14 20P BLACK 3/4" PAN HEAD SCREW ...

video assembly tip is available at www.sauder.com/services/tips å Assemble your unit on a carpeted fl oor or on the empty carton to avoid scratching your unit or the fl oor. å To begin assembly, push a SAUDER TWIST-LOCK® FASTENER (7F) into the large holes in the SHELF (E) and FRONT PANELS (J). 422197 www.sauder.co ...

the LEGS (F and G). å Push eight HIDDEN CAMS (1F) into the exact holes shown in the ENDS (A and B). Arrow Arrow 1F The arrow in the HIDDEN CAM must point toward the hole in the edge of the board. Hole 1F Arrow (8 used) A B (8 used) F F G G ...

eight BLACK 1-15/16" FLAT HEAD SCREWS (113S). å NOTE: You may want to start each SCREW a few turns before completely tightening any of them. Step 3 422197 www.sauder.com/services Page 7 BLACK 1-15/16" FLAT HEAD SCREW (8 used in this step) 113S E J J Surface without TWIST-LOCK® FASTENERS Surface with TWI ...

PANELS (J). Tighten fi ve TWIST-LOCK® FASTENERS. å Fasten the UPRIGHT (D) to the SHELF (E). Use three BLACK 1-15/16" FLAT HEAD SCREWS (113S). How to use the SAUDER TWIST-LOCK® FASTENER 1. Insert the dowel end of the FASTENER into the hole of the adjoining ...

Inspect the parts thoroughly before assembling. Disassembly of glued parts is extremely diffi cult. Caution ! 54M 15F å First, fi ll the exact holes shown in the BOTTOM (C) 1/4 to 1/2 full with GLUE (54M). Then, insert four WOOD DOWELS (15F) into the holes. Wipe ...

å Fill the holes in the RIGHT END (A) 1/4 to 1/2 full with GLUE (54M). å Fasten the RIGHT END (A) to the SHELF (E) and FRONT PANELS (J). Tighten fi ve TWIST-LOCK® FASTENERS. å NOTE: Be sure the WOOD DOWELS in the BOTTOM (C) insert into the holes in the RIGHT END. Wipe away the excess GLUE ...